RPM Green Gearbox Housing And Rear Mounts For Traxxas 2Wd Vehicles

This is the optional RPM Hybrid Gearbox Housing in Green
for the Traxxas 1/10 scale 2WD Slash, Stampede, E-Rustler and Bandit.

FEATURES:
0.12" (3mm) thick 6061 T6 aluminum motor plate provides strength to
    lock in gear mesh, and much better heat dissipation than stock plastic
    motor plate
Motor plate is separate from rear bumper installs removing damage to
    the plate in case of a rear accident
Formed nylon gearbox real estate with stock bumper installing holes
Different real estate and rear installs permit transmission upkeep
    without affecting suspension settings
0° and 3° formed rear installs offer tighter tolerances and less slop
    than machined parts for much better camber and toe angle retention

INCLUDES:
2 Gearbox Housings, Motor Plate, two 0° and two 3° Rear Installs and
    Directions

The listed below product likewise pairs truly well with the product being discussed.

Steel Top Drive Gear 22T

This is the 22 tooth, hardened steel top drive gear that fits numerous Traxxas
vehicles. .
Consists of: 1 gear just

You will certainly like this item if you have the item earlier discussed.

30T Idler Gear Steel

This is the optional Steel Idler Gear for different Traxxas Vehicles.

FEATURES:
Steel construction

INCLUDES:
One steel 30T idler gear

REQUIRES:
Setup on automobile

Many others have actually purchased this product in addition to the product that you are currently checking out.

Shaft Slipper Clutch

This is a Slipper Clutch Shaft for the Traxxas Rustler XL
and Stampede XL.

FEATURES:
Steel construction
_
Roll pin pre-installed

INCLUDES:
One slipper clutch set

SPECIFICATIONS:
Length: 1.98" (50mm)
Size: .21" ( 5mm)

COMMENTS:
This part will fit both the standard and XL version of the Rustler
or Stampede.

Want another terrific product to match the above discussed product?

5 X 11 X 4Mm Ball Bearing (2) Blue Rubber Shield R Evo

This is a 2 pack of 5X11mm Ball Bearings for the Traxxas Revo.

FEATURES:
Metal bearing construction
Blue rubber dirt guards

INCLUDES:
(2) 5X11mm ball bearings, Part #5116

SPECIFICATIONS:
Inside size: 3/16" (5mm)
Outdoors size: 7/16" (11mm)
Width: 5/32" (4mm)