RPM Black Esc Cage For The Castle Sidewinder 4 Esc

This lightweight Sidewinder 4 ESC Cage fits in the stock area on the Traxxas Slash 2wd, Slash 2wd LCG, Slash 4x4, Slash 4x4 LCG, Stampede 4x & Rally, while also dealing with other Traxxas 1/10th scale vehicles.

This cage permits the ESC to be kept up or without a fan. It encases the ESC body only, leaving the whole ESC fan totally free to do its job. Castle did a fantastic job with airflow through the Sidewinder 4, and the RPM ESC cage enhances that free-flowing air motion. Air channels along both sides of the ESC permit air motion along the sides of the case, while the low profile sides leave all of the integrated air vents on the ESC totally free and clear to stream air properly.

Each ESC Cage is created to streamline ESC installation and upkeep of the vehicle. Two screws hold the whole assembly to the chassis, that's it! No more struggling with gooey double-sided tape to eliminate the ESC to clean your vehicle or move the electronics to another car.

Also consisted of is a separate, encased on/off switch install that bolts directly to the cage in among 4 locations/orientations for severe versatility. Given that the switch connects to the cage, no extra time is needed to remove it during upkeep or if you decide to swap the ESC in between vehicles.

Each RPM ESC Cage is made from RPM's unbelievably difficult mix of engineering grade nylons for a lifetime of stress-free efficiency. Each cage is backed by RPM's minimal lifetime service warranty against breakage.

Item Developed: 08/13/2018