ROBART LH Offset Pneumatic Tail Wheel

This is a big scale retractable tailwheel with left-hand offset axle for the
tailwheel and air cylinder. For use with aircrafts approximately 40 lbs.

FEATURES:
This System Comes Pre-Assembled with an Air Cylinder and Tailwheel
    Axle Attached.
Steerable with a Pull-Pull System Attached to the Rudder Servo.

INCLUDES:
One Retractable Tailwheel w/Air Cylinder & 3/16"Balanced out Tailwheel Axle
One Instruction/Parts List Sheet

NEEDS:
Pressure Tubing to Reach from the Main Control System to the Air Ram
One 2" Tailwheel
Plastic Sleeved Pull-Pull Steel Steering Cables(Goes to Rudder Servo)
Four #6-32 Installing Screws
Four #6-32 Blind Nuts
Four 3/8" x 1/2" Maple Mounting Blocks
Four Dowel Pins (Used to Mount Maple Mounting Blocks to Bulkhead)
Epoxy
SPECIFICATIONS:
Retract Installing Brace Height: 2-11/16" (68.5mm)
Retract Mounting Brace Width: 2"
Height from Axle Center to Bottom Retract Brace: 2-1/8" approx.
Extended Length from Axle Center to Retract Brace Mount: 3-11/16"
Retracted Length from Axle Center to Retract Brace Mount: 4-1/8"

COMMENTS:
On the Air Cylinder: Extend Fitting is Found Forward and the
Retract Fitting is Found Aft.
For the Fork Axle Variation, utilize ROBQ2230.