RJX Servo Wire Braided Sleeving Wrap Color Blue/White (1m)

Information



Wanting to clean up the appearance of your helicopter, aircraft of RC automobile & secure your servo lines from chaffing? Servo Line Covering is an easy method to secure your servo wires, adding a tidy, visual look to your RC device, and can be installed in a matter of minutes. Select from our exciting line of different colors to include a whole new look to your RC machine!

Included In Package:
(1) 1M (3.28 ft.) Servo Wire Braided Sleeving Wrap
(1) 9 in. Heat Shrink Wrap
How Do I Install Servo Line Covering?

Simply remove your servo(s) from the receiver, measure the length of covering you will need for your servo wire(s), and open one end of the covering and insert the servo terminal inside. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off a suitable sized piece of the included heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat gun to diminish it down around the covering, therefore offering you a flush, tight fit over the previously torn servo covering. Do the same with the end of your servo wire, being careful to leave the terminal bare so it can easily plug into your receiver. Likewise, make sure to take note of the servo wire polarity if you cover the full wire – this will make sure that you will know what direction to plug your servo terminal into your receiver.