RJX Servo Wire Braided Sleeving Wrap Color Black 3 (1m)

Details



Looking to clean up the look of your helicopter, airplane of RC vehicle & safeguard your servo lines from chaffing? Servo Line Covering is an easy way to safeguard your servo wires, adding a clean, visual look to your RC machine, and can be set up in a matter of minutes. Choose from our interesting line of different colors to add a whole make over to your RC machine!

Included In Plan:
(1) 1M (3.28 ft.) Servo Wire Braided Sleeving Wrap
(1) 9 in. Heat Shrink Wrap
How Do I Install Servo Line Covering?
Simply eliminate your servo(s) from the receiver, determine the length of covering you will need for your servo wire(s), and open one end of the covering and insert the servo terminal within. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off an appropriate sized piece of the included heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat gun to diminish it down around the covering, therefore offering you a flush, tight fit over the formerly frayed servo covering. Do the exact same with completion of your servo wire, taking care to leave the terminal bare so it can easily connected into your receiver. Likewise, make certain to remember of the servo wire polarity if you cover the full wire – this will guarantee that you will know what instructions to plug your servo terminal into your receiver.