RJX Servo Wire Braided Sleeving Wrap Color Black 3 (1m)

Details



Seeking to removal the appearance of your helicopter, plane of RC automobile & safeguard your servo lines from chaffing? Servo Line Covering is a simple way to safeguard your servo wires, adding a tidy, visual seek to your RC maker, and can be installed in a matter of minutes. Pick from our interesting line of varied colors to include a whole new look to your RC machine!

Included In Package:
(1) 1M (3.28 ft.) Servo Wire Braided Sleeving Wrap
(1) 9 in. Heat Shrink Wrap
How Do I Install Servo Line Covering?
Simply eliminate your servo(s) from the receiver, determine the length of covering you will need for your servo wire(s), and open one end of the covering and place the servo terminal inside. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off a proper sized piece of the consisted of heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat gun to shrink it down around the covering, thus providing you a flush, tight fit over the formerly frayed servo covering. Do the same with the end of your servo wire, taking care to leave the terminal bare so it can quickly plug into your receiver. Also, be sure to bear in mind of the servo wire polarity if you cover the full wire – this will ensure that you will know what direction to plug your servo terminal into your receiver.