RJX Servo Wire Braided Sleeving Wrap Color Black 2 (1m)

Wanting to tidy up the look of your helicopter, airplane of RC automobile & safeguard your servo lines from chaffing? Servo Line Covering is an easy way to safeguard your servo wires, including a tidy, aesthetic seek to your RC machine, and can be set up in a matter of minutes. Choose from our exciting line of different colors to add an entire makeover to your RC machine!

Included In Package:
(1) 1M (3.28 ft.) Servo Wire Braided Sleeving Wrap
(1) 9 in. Heat Shrink Wrap

How Do I Set up Servo Line Covering?
Simply remove your servo(s) from the receiver, determine the length of covering you will require for your servo wire(s), and open one end of the covering and insert the servo terminal inside. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off a proper sized piece of the consisted of heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat weapon to shrink it down around the covering, hence offering you a flush, tight fit over the previously frayed servo covering. Do the exact same with the end of your servo wire, taking care to leave the terminal bare so it can easily plug into your receiver. Likewise, make sure to remember of the servo wire polarity if you cover the full wire – this will guarantee that you will know what instructions to plug your servo terminal into your receiver.