RJX Servo Wire Braided Sleeving Wrap - Black and Orange (1m)

Details



Looking to clean up the appearance of your helicopter, plane of RC vehicle & protect your servo lines from chaffing? Servo Line Covering is a simple method to protect your servo wires, adding a clean, aesthetic seek to your RC machine, and can be set up in a matter of minutes. Pick from our amazing line of different colors to include an entire new look to your RC machine!

Included In Package:
(1) 1M (3.28 ft.) Servo Wire Braided Sleeving Wrap
(1) 9 in. Heat Shrink Wrap
How Do I Install Servo Line Covering?
Simply remove your servo(s) from the receiver, determine the length of covering you will need for your servo wire(s), and open one end of the covering and place the servo terminal within. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off a suitable sized piece of the included heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat weapon to diminish it down around the covering, therefore giving you a flush, tight fit over the formerly torn servo covering. Do the very same with completion of your servo wire, taking care to leave the terminal bare so it can quickly plug into your receiver. Also, make sure to take note of the servo wire polarity if you cover the complete wire – this will guarantee that you will know what instructions to plug your servo terminal into your receiver.