RJX Servo Line - Deep Blue (1M)

Aiming to clean up the appearance of your helicopter, airplane of RC vehicle & protect your servo lines from chaffing? Servo Line Covering is an easy way to protect your servo wires, adding a tidy, visual seek to your RC maker, and can be set up in a matter of minutes. Select from our interesting line of varied colors to include an entire makeover to your RC machine!

Included In Bundle:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply eliminate your servo(s) from the receiver, measure the length of covering you will require for your servo wire(s), and open one end of the covering and insert the servo terminal within. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off a suitable sized piece of the consisted of heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat weapon to shrink it down around the covering, thus giving you a flush, tight fit over the previously frayed servo covering. Do the very same with completion of your servo wire, being careful to leave the terminal bare so it can quickly plug into your receiver. Also, be sure to take note of the servo wire polarity if you cover the full wire - this will make sure that you will understand what direction to plug your servo terminal into your receiver.