RJX Servo line Color Blue/Black (1m)

Seeking to tidy up the appearance of your helicopter, plane of RC car & protect your servo lines from chaffing? Servo Line Covering is an easy way to protect your servo wires, including a clean, visual look to your RC device, and can be set up in a matter of minutes. Select from our amazing line of varied colors to include a whole makeover to your RC machine!

Included In Package:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply remove your servo(s) from the receiver, determine the length of covering you will require for your servo wire(s), and open one end of the covering and insert the servo terminal inside. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off a suitable sized piece of the included heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat weapon to shrink it down around the covering, hence giving you a flush, tight fit over the formerly frayed servo covering. Do the exact same with the end of your servo wire, bewaring to leave the terminal bare so it can quickly connected into your receiver. Also, be sure to take note of the servo wire polarity if you cover the complete wire – this will ensure that you will know what instructions to plug your servo terminal into your receiver.

Here is a fantastic thing that numerous others have actually purchased the very same time.

Servo line Color Black and Red

Seeking to tidy up the appearance of your helicopter, plane of RC car & protect your servo lines from chaffing? Servo Line Covering is an easy way to protect your servo wires, including a clean, visual look to your RC device, and can be set up in a matter of minutes. Select from our amazing line of varied colors to include a whole makeover to your RC machine!

Included In Package:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Install Servo Line Covering?

Simply remove your servo(s) from the receiver, determine the length of covering you will require for your servo wire(s), and open one end of the covering and insert the servo terminal inside. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off a suitable sized piece of the included heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat weapon to shrink it down around the covering, hence giving you a flush, tight fit over the formerly frayed servo covering. Do the exact same with the end of your servo wire, bewaring to leave the terminal bare so it can quickly connected into your receiver. Also, be sure to take note of the servo wire polarity if you cover the complete wire – this will ensure that you will know what instructions to plug your servo terminal into your receiver.