RJX Servo line Color Blue/Black (1m)

Planning to tidy up the look of your helicopter, aircraft of RC car & protect your servo lines from chaffing? Servo Line Covering is a simple method to protect your servo wires, adding a clean, aesthetic aim to your RC machine, and can be set up in a matter of minutes. Choose from our exciting line of diverse colors to include a whole new look to your RC machine!

Included In Plan:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Set up Servo Line Covering?

Simply eliminate your servo(s) from the receiver, determine the length of covering you will need for your servo wire(s), and open one end of the covering and place the servo terminal within. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off a proper sized piece of the consisted of heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat gun to shrink it down around the covering, therefore providing you a flush, tight fit over the formerly frayed servo covering. Do the very same with completion of your servo wire, being careful to leave the terminal bare so it can easily plug into your receiver. Also, be sure to bear in mind of the servo wire polarity if you cover the full wire – this will guarantee that you will know exactly what direction to plug your servo terminal into your receiver.

Right here is a wonderful product that several others have actually bought at the same time.

Servo line Color Black and Red

Planning to tidy up the look of your helicopter, aircraft of RC car & protect your servo lines from chaffing? Servo Line Covering is a simple method to protect your servo wires, adding a clean, aesthetic aim to your RC machine, and can be set up in a matter of minutes. Choose from our exciting line of diverse colors to include a whole new look to your RC machine!

Included In Plan:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Set up Servo Line Covering?

Simply eliminate your servo(s) from the receiver, determine the length of covering you will need for your servo wire(s), and open one end of the covering and place the servo terminal within. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pressing the terminal forward.

Once your servo wire is covered, cut off a proper sized piece of the consisted of heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat gun to shrink it down around the covering, therefore providing you a flush, tight fit over the formerly frayed servo covering. Do the very same with completion of your servo wire, being careful to leave the terminal bare so it can easily plug into your receiver. Also, be sure to bear in mind of the servo wire polarity if you cover the full wire – this will guarantee that you will know exactly what direction to plug your servo terminal into your receiver.