RJX Servo line Color Black & Green

Aiming to clean up the appearance of your helicopter, plane of RC automobile & safeguard your servo lines from chaffing? Servo Line Covering is an easy method to safeguard your servo wires, adding a clean, visual look to your RC maker, and can be set up in a matter of minutes. Pick from our exciting line of varied colors to include a whole make over to your RC machine!

Included In Package:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Set up Servo Line Covering?

Simply eliminate your servo(s) from the receiver, determine the length of covering you will require for your servo wire(s), and open one end of the covering and place the servo terminal inside. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off an appropriate sized piece of the consisted of heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat weapon to shrink it down around the covering, thus giving you a flush, tight fit over the previously frayed servo covering. Do the same with completion of your servo wire, bewaring to leave the terminal bare so it can easily plug into your receiver. Likewise, make certain to keep in mind of the servo wire polarity if you cover the complete wire – this will guarantee that you will understand what instructions to plug your servo terminal into your receiver.

This is a great enhancement to the item currently being talked about.

Servo line Color Black and Red

Aiming to clean up the appearance of your helicopter, plane of RC automobile & safeguard your servo lines from chaffing? Servo Line Covering is an easy method to safeguard your servo wires, adding a clean, visual look to your RC maker, and can be set up in a matter of minutes. Pick from our exciting line of varied colors to include a whole make over to your RC machine!

Included In Package:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Set up Servo Line Covering?

Simply eliminate your servo(s) from the receiver, determine the length of covering you will require for your servo wire(s), and open one end of the covering and place the servo terminal inside. It works best to “inch worm” your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off an appropriate sized piece of the consisted of heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat weapon to shrink it down around the covering, thus giving you a flush, tight fit over the previously frayed servo covering. Do the same with completion of your servo wire, bewaring to leave the terminal bare so it can easily plug into your receiver. Likewise, make certain to keep in mind of the servo wire polarity if you cover the complete wire – this will guarantee that you will understand what instructions to plug your servo terminal into your receiver.