RJX Servo line Color Black and Red

Aiming to clean up the look of your helicopter, aircraft of RC car & protect your servo lines from chaffing? Servo Line Covering is an easy way to protect your servo wires, including a clean, visual want to your RC machine, and can be installed in a matter of minutes. Choose from our interesting line of different colors to add a whole makeover to your RC machine!

Included In Plan:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Set up Servo Line Covering?

Simply eliminate your servo(s) from the receiver, determine the length of covering you will need for your servo wire(s), and open one end of the covering and insert the servo terminal within. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off an appropriate sized piece of the consisted of heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat gun to diminish it down around the covering, hence providing you a flush, tight fit over the previously frayed servo covering. Do the very same with completion of your servo wire, being careful to leave the terminal bare so it can quickly connected into your receiver. Also, be sure to keep in mind of the servo wire polarity if you cover the full wire - this will guarantee that you will know what instructions to plug your servo terminal into your receiver.

The below thing likewise sets really well with the thing being talked about.

Servo line Color Black & Green

Aiming to clean up the look of your helicopter, aircraft of RC car & protect your servo lines from chaffing? Servo Line Covering is an easy way to protect your servo wires, including a clean, visual want to your RC machine, and can be installed in a matter of minutes. Choose from our interesting line of different colors to add a whole makeover to your RC machine!

Included In Plan:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Set up Servo Line Covering?

Simply eliminate your servo(s) from the receiver, determine the length of covering you will need for your servo wire(s), and open one end of the covering and insert the servo terminal within. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and gradually inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off an appropriate sized piece of the consisted of heat diminish, and slide it over the covering till it is flush with the servo itself. Heat the diminish wrap with a soldering iron or heat gun to diminish it down around the covering, hence providing you a flush, tight fit over the previously frayed servo covering. Do the very same with completion of your servo wire, being careful to leave the terminal bare so it can quickly connected into your receiver. Also, be sure to keep in mind of the servo wire polarity if you cover the full wire – this will guarantee that you will know what instructions to plug your servo terminal into your receiver.