RJX Servo Line - Black and Dark Blue (1m)

Planning to clean up the appearance of your helicopter, airplane of RC automobile & secure your servo lines from chaffing? Servo Line Covering is an easy way to secure your servo wires, including a clean, aesthetic look to your RC maker, and can be installed in a matter of minutes. Select from our interesting line of different colors to include an entire make over to your RC machine!

Included In Package:

(1) 1M (3.28 ft.) Servo Line Covering

(1) 9 in. Heat Shrink Wrap

How Do I Set up Servo Line Covering?

Simply eliminate your servo(s) from the receiver, measure the length of covering you will need for your servo wire(s), and open one end of the covering and place the servo terminal within. It works best to "inch worm" your servo wire by holding the terminal inside the servo covering, and slowly inching the covering over the terminal, and pushing the terminal forward.

Once your servo wire is covered, cut off a proper sized piece of the consisted of heat shrink, and slide it over the covering till it is flush with the servo itself. Heat the shrink wrap with a soldering iron or heat gun to shrink it down around the covering, therefore providing you a flush, tight fit over the previously frayed servo covering. Do the same with the end of your servo wire, taking care to leave the terminal bare so it can easily plug into your receiver. Likewise, make certain to keep in mind of the servo wire polarity if you cover the complete wire – this will guarantee that you will understand exactly what instructions to plug your servo terminal into your receiver.