Proline Body Mount Thumbwasher Kit

This is the Pro-Line Body Mount Thumbwasher Kit.

FEATURES:
For the #6070-00 (PROC7000), #6071-00 (PROC7100), #6087-00
    (PROC6087) Pro-Line Body Mount Kits

CONSISTS OF:
Four each Thumbwashers, 4x12mm Set Screws, and O-Rings

This thing is regularly purchased with the above pointed out thing.



This is the optional Pro-Line Body Mount Replacement Set
for the Traxxas 2WD Slash.

FEATURES:
Constructed of nylon, black in color
Replaces body installs in the Pro-Line #6070-00 (PROC7000) Prolonged
    Body Mount Set
Completely adjustable installs fit any body perfectely
Long body installs included to fit rally car bodies
Screw-on body install system eliminates metal clips

CONSISTS OF:
Front and Rear Body Mounts and Posts Tree

Below is a excellent thing that lots of others have actually bought at the very same time.



This is a CVD Coupling Rebuild Set used for numerous Monster Trucks.
Works for the TMaxx/Emaxx, Revo, Tamiya TNX, Savage 21 & 25, Losi LST

FEATURES:
Black oxide rust preventive finish on the coupling

CONSISTS OF:
(2) Cross pin 2.5 x 16mm
(2) Coupling 6mm diameter x 9mm length
(2) Set screw 4.0 x 3mm

You will certainly enjoy this thing if you have the thing just above stated.

Extended Fr/Re Body Mounts Revo 3.3/Summit

These are the optional Pro-Line Extended Front and Rear Body Mounts
for the Traxxas Revo 3.3, E-Revo, and Summit.

FEATURES:
Permits any body to be mounted to the Traxxas Revo 3.3, E-Revo, and
Top
Secure-Loc Cap screw-on body install system eliminates body clips
Nylon building and construction, black in color

CONSISTS OF:
Front and Rear Body Mounts and Posts
Mounting Hardware

This thing is regularly purchased with the above pointed out thing.

Slash 2Wd Low Cg Chassis Conversion Kit

This is the optional Low CG Conversion Set for the
1/10 scale 2WD Traxxas Slash.

FEATURES:
Reduces the chassis 1" (25.4mm) for much better handling and greater
    catching speed
Holds battery and electronics as deep in chassis as possible
45% lower battery position

CONSISTS OF:
Chassis
Lower Chassis
Two Nerf Bars
Battery Hold Down with Front and Rear Retainers
Two Front Shock Springs
Hardware and Instructions

Regularly purchased with the thing that you are currently checking out.

Front A-Arm, For Traxxas Slash, Rustler, Stampede, Nitro Slash,

This is a set of Sturdy Front-A Arms in Red
for the Traxxas Electric Rustler, Stampede, Outlaw, Slash and Nitro Slash.

FEATURES:
Composite nylon building and construction, red in color
Nearly 25% lighter than stock versions
Increased clearance locations in the outer portion allows increased
    droop travel when used with RPM #80372 and #80382 oversized
    bearing providers

CONSISTS OF:
Two Sturdy Front-A Arms in Red

Get this thing to boost the one you are reading around.

Extended Fr/Re Body Mnts Slash 4x4

This is the optional Pro-Line Extended Body Mount Set for the
1/10 scale Traxxas Slash 4x4 Short Course Trucks.

FEATURES:
Adjustable front and rear body installs enable a wide variety of bodies
    to be used including rally car bodies
Constructed of nylon, black in color
Screw-on body install system eliminates metal clips

CONSISTS OF:
Front and Rear Body Mounts and Posts with Mounting Hardware