Proline Body Mount Thumbwasher Kit

This is the Pro-Line Body Mount Thumbwasher Kit.

FEATURES:
For the #6070-00 (PROC7000), #6071-00 (PROC7100), #6087-00
    (PROC6087) Pro-Line Body Mount Kits

CONSISTS OF:
4 each Thumbwashers, 4x12mm Set Screws, and O-Rings

This item is often purchased with the above discussed item.



This is the optional Pro-Line Body Mount Replacement Set
for the Traxxas 2WD Slash.

FEATURES:
Constructed of nylon, black in color
Changes body installs in the Pro-Line #6070-00 (PROC7000) Extended
    Body Mount Set
Entirely adjustable installs fit any body perfectely
Long body installs included to fit rally automobile bodies
Screw-on body install system eliminates metal clips

CONSISTS OF:
Front and Rear Body Mounts and Posts Tree

Here is a fantastic item that numerous others have bought at the same time.



This is a CVD Coupling Rebuild Set utilized for numerous Beast Trucks.
Works for the TMaxx/Emaxx, Revo, Tamiya TNX, Savage 21 & 25, Losi LST

FEATURES:
Black oxide rust preventive finish on the coupling

CONSISTS OF:
(2) Cross pin 2.5 x 16mm
(2) Coupling 6mm diameter x 9mm length
(2) Set screw 4.0 x 3mm

You will certainly like this item if you have the item earlier pointed out.

Extended Fr/Re Body Mounts Revo 3.3/Summit

These are the optional Pro-Line Extended Front and Rear Body Mounts
for the Traxxas Revo 3.3, E-Revo, and Summit.

FEATURES:
Permits any body to be installed to the Traxxas Revo 3.3, E-Revo, and
Summit
Secure-Loc Cap screw-on body install system eliminates body clips
Nylon building, black in color

CONSISTS OF:
Front and Rear Body Mounts and Posts
Installing Hardware

This item is often purchased with the above discussed item.

Slash 2Wd Low Cg Chassis Conversion Kit

This is the optional Low CG Conversion Set for the
1/10 scale 2WD Traxxas Slash.

FEATURES:
Reduces the chassis 1" (25.4mm) for much better handling and greater
    cornering speed
Holds battery and electronic devices as deep in chassis as possible
45% lower battery position

CONSISTS OF:
Chassis
Lower Chassis
Two Nerf Bars
Battery Hold Down with Front and Rear Retainers
Two Front Shock Springs
Hardware and Instructions

Regularly purchased with the item that you are presently checking out.

Front A-Arm, For Traxxas Slash, Rustler, Stampede, Nitro Slash,

This is a set of Heavy Duty Front-A Arms in Red
for the Traxxas Electric Rustler, Stampede, Bandit, Slash and Nitro Slash.

FEATURES:
Composite nylon building, red in color
Nearly 25% lighter than stock versions
Increased clearance locations in the outer portion enables increased
    sag travel when utilized with RPM #80372 and #80382 oversized
    bearing providers

CONSISTS OF:
Two Heavy Duty Front-A Arms in Red

Get this item to boost the one you are reading around.

Extended Fr/Re Body Mnts Slash 4x4

This is the optional Pro-Line Extended Body Mount Set for the
1/10 scale Traxxas Slash 4x4 Short Course Trucks.

FEATURES:
Adjustable front and rear body installs allow a wide range of bodies
    to be utilized consisting of rally automobile bodies
Constructed of nylon, black in color
Screw-on body install system eliminates metal clips

CONSISTS OF:
Front and Rear Body Mounts and Posts with Installing Hardware