E-Flite 60-Amp Pro Switch-Mode BEC Brushless ESC (V2)

The E-flite® 60-Amp Pro Switch-Mode BEC Brushless ESC (V2). This is a premium sensorless brushless electronic speed control with an incorporated switch-mode BEC that is extremely light-weight and effective. It can operate without the requirement for a separate receiver battery to power your servos and receivers, saving you weight and complication.

Features
Approximately 60 amps constant current with proper air circulation and 75 amps break current (15 seconds)
5A constant current, 5V switch-mode BEC circuit (proper cooling and airflow required)
Stronger BEC for assistance of most 3-axis stabilization systems
Drive up to 7 analog or 6 digital standard-sized servos with the BEC on any advised input voltage
3- to 6-cell Li-Po, 9- to 18-cell Ni-MH/Ni-Cd input voltage
Finned heat sinks
Programmable motor braking
Safe power-arm mode avoids unexpected starts
Programmable low voltage cutoff with settings for 3-cell Li-Po (9V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V) or 74% of battery beginning voltage
Programmable throttle input range (1.1ms???1.9ms or 1.2ms???1.8ms)
Programmable soft start for helis and planes
Auto motor closed down if signal is lost or there is disturbance
Programmable timing???5 user-selectable ranges for usage with a big variety of brushless motors
Uses new smaller MOSFET innovation to lessen weight
Radio system power on/off switch
Pre-wired adapters???E-flite® EC3T port on battery input and 3.5mm gold bullet adapters on motor output leads

Specifications
Amperage: 40-60
Brake: Yes - Programmable
Cells w/BEC: 3-6S Li-Po or 9-18 Ni-MH/Ni-Cd
Constant Optimum Current: 50 - 75A
Height: 0.61 in (15.5mm)
Input Adapter Types: EC3
Input Voltage: 10.8V - 22.2V
Length: 2.85 in (73.0mm)
Momentary Peak Current: 15 sec @ 75A with proper cooling air circulation
Output Adapter Types: 13 AWG with 3.5mm female gold bullet adapters
Type: Brushless
Weight: 2.65 oz (75.0 g)
Width: 1.30 in (33.0mm)
Wire Gauge: 13AWG