MST FMX 2.0 LCG 1/10 RWD Electric Drift Car Kit (No Body)

The MST FMX 2.0 "LCG" 1/10 RWD Electric Drift Vehicle Package is a mid motor, rear wheel drive package created with the enthusiast in mind. Featuring high quality carbon fiber and molded composite parts, incredibly smooth shocks and a huge selection of tuning settings readily available right out of the box, this package provides fantastic steering angles in a mid-motor platform that is fantastic for both newbies and experienced lovers alike. This redesigned LCG aluminum motor mount reduces the center of mass of the motor by approximately 5mm than the last generation, which further increases the stability and control. The freshly created carbon upper deck is separated from the motor mount, increasing the torsion of the cars and truck body, decreasing the height of the upper deck, and more vibrant and streamlined visual looks.

NOTE: Wheels, tires and electronic devices displayed in pictures are for illustrative purposes only and are not included. See needed to complete list listed below for a complete list of products needed to complete the design.   

Functions:

Middle motor installs and central configurations

Carbon fiber chassis with double vertical carbon fiber upper deck

Redesigned fantastic front suspension system

Adjustable Ackerman angle variation in 2 sections of steering system

Front steering wheel base KPI at 6 degrees. - 0.5 hauling range of axle

Redesigned front upper arm inside seat supports 10-steps bi-side modifications

Full dust-proof rear transmission with the bevel gear shaft drive

Requirement ball differential

Variable 2nd reduction ratio of the rear axle in a total of 6 variable range of 1.78-3.82 (standard 3.82)

Revised MB multi-link rear suspension system

Rear drive system geared up with the steel CVD drive shaft

Standard aluminum smooth hydraulic damper set

Geared up with the high-smooth metal ball ports

Requirement gearing up with the sensible cars and truck brake and caliper set

Resigned aluminum motor mount

Updated carbon upper deck

Requirements: 

Type: 1:10 Drift Vehicle  

Wheelbase: 257mm 

Width: 190mm  

Drive Mode:  RWD  

Caster: Adjustable 6/8/10/12 degrees  

Camber:  Adjustable 0 to -12 degrees

Needed to Total:

1/10 Wander Body & Paint

Motor & ESC

2 Channel Radio System (minimum)

Steering Servo

Shorty LiPo Battery & Battery charger

Wheels & Tires