HPI Spur Gear, 47 Tooth, Savage

This is the 47T Spur Equipment for the HPI Savage .25.

FEATURES:
Black plastic construction

CONSISTS OF:
One 47T spur gear
One clutch pad HPIC7231

This is a superb addition to the thing presently being gone over.

Exhaust Manifold Spring, 3.2X75x0.7Mm X 56, (2Pcs), Savage X

These are the Replacement Exhaust Manifold Springs for the HPI Savage.

FEATURES:
Black Steel Manifold Springs.

INCLUDES:
2 Springs.

REQUIRES:
HPI Savage.

SPECS:
Length: 91 mm (3.58")
Spring Diameter: 3.2 mm (0.1258")
Wire Diameter: 0.7 mm (0.0275")

COMMENTS:
None.

This thing praises the main item here.

One Way Bearing, For Pullstart Nitro Star G3.0, S-25, F Series

This is the One-Way bearing for the HPI Nitro Star 21BB engine.
** Also fits the Roto Start for the Savage.**
    This One-Way Bearing permits the recoil starter to get hold of
the crankshaft to start the engine and spin freely in the opposite direction.

FEATURES:
Steel construction

CONSISTS OF:
One one-way bearing
One installation guideline sheet

REQUIRES:
Setting up in recoil unit

SPECIFICATIONS:
General Length: 12mm (.472")
Hex Width: 12mm (.472")
Inner Diameter: 6mm (.218")

COMMENTS:
If recoil unit is required, utilize HPIG1428

Get this thing to improve the one you are reading about.

Dual Fiberglass Brake Disk And Plate Set, 19X35x2.5Mm, Savage X

This is the HPI Fiberglass Brake Disk for
usage with the Savage X 4.6

FEATURES:
Fiberglass construction
Aluminum Disc Plates
For usage with the 6 x 19 x 21mm Cup Joints (HPIC6322)

CONSISTS OF:
2 Fiberglass Brake Disk
Three disc plates
Installing hardware

REQUIRES:
Setup on the automobile

SPECIFICATIONS:
Diameter: 35.5mm
Density: 2.7mm

COMMENTS:
Also works on the Savage XL
For the Cup Joint, order HPIC6322

This thing praises the above gone over thing.

Stainless Slipper Disk

This is the Stock Replacement Slipper Plate for the HPI Nitro Rush.
This part is located on the spur gear.

FEATURES:
Stainless steel construction

CONSISTS OF:
One slipper plate

REQUIRES:
Setup on the automobile

SPECIFICATIONS:
External size: 33mm (1.30")
Inner size: 16.5mm (0.65")
Density: 1.4mm (0.06")

COMMENTS:
This part specifies to the Nitro Rush.