HPI Spur Gear, 47 Tooth, Savage

This is the 47T Spur Gear for the HPI Savage .25.

FUNCTIONS:
Black plastic building and construction

CONSISTS OF:
One 47T spur equipment
One clutch pad HPIC7231

This is a amazing enhancement to the thing currently being discussed.

Exhaust Manifold Spring, 3.2X75x0.7Mm X 56, (2Pcs), Savage X

These are the Replacement Exhaust Manifold Springs for the HPI Savage.

FEATURES:
Black Steel Manifold Springs.

INCLUDES:
Two Springs.

REQUIRES:
HPI Savage.

SPECS:
Length: 91 mm (3.58")
Spring Size: 3.2 mm (0.1258")
Wire Size: 0.7 mm (0.0275")

COMMENTS:
None.

This thing compliments the main item below.

One Way Bearing, For Pullstart Nitro Star G3.0, S-25, F Series

This is the One-Way bearing for the HPI Nitro Star 21BB engine.
** Also fits the Roto Start for the Savage.**
    This One-Way Bearing permits the recoil starter to get hold of
the crankshaft to begin the engine and spin easily in the opposite direction.

FEATURES:
Steel building and construction

CONSISTS OF:
One one-way bearing
One installation instruction sheet

NEEDS:
Setting up in recoil device

SPECS:
Overall Length: 12mm (.472")
Hex Width: 12mm (.472")
Inner Size: 6mm (.218")

COMMENTS:
If recoil device is needed, utilize HPIG1428

Get this thing to improve the one you read around.

Dual Fiberglass Brake Disk And Plate Set, 19X35x2.5Mm, Savage X

This is the HPI Fiberglass Brake Disk for
use with the Savage X 4.6

FUNCTIONS:
Fiberglass building and construction
Aluminum Disc Plates
For use with the 6 x 19 x 21mm Cup Joints (HPIC6322)

CONSISTS OF:
Two Fiberglass Brake Disk
3 disc plates
Installing hardware

NEEDS:
Installation on the automobile

SPECS:
Size: 35.5mm
Density: 2.7mm

COMMENTS:
Also works on the Savage XL
For the Cup Joint, order HPIC6322

This thing compliments the above discussed thing.

Stainless Slipper Disk

This is the Stock Replacement Slipper Plate for the HPI Nitro Rush.
This part lies on the spur gear.

FEATURES:
Stainless steel building and construction

CONSISTS OF:
One slipper plate

NEEDS:
Installation on the automobile

SPECS:
Outer size: 33mm (1.30")
Inner size: 16.5mm (0.65")
Density: 1.4mm (0.06")

COMMENTS:
This part is specific to the Nitro Rush.