HPI Nitro Star T3.0 Engine, W/ Pullstart, 6.5Mm Rotary Carb, Standar

This is the HPI Nitro Star T3.0 Engine for use
with the RTR Nitro RS4 3 Evo+

FEATURES:
1-piece black crankcase
6.5mm Rotary Carb
Non-ringed/ ABC-type engine
Standard crankshaft
Side exhaust
Heatsink Head

INCLUDES:
One put together engine with radiance plug
One instruction manual and sticker sheet
One air filter with instruction sheet
3 zip ties
One hex wrench

SPECS:
Height from crankcase bottom to top of cylinder head: 3.8" (96mm)
Width consisting of installing tabs: 1.57" (40mm)
Width listed below installing tabs: 1.2" (31mm)
Width between installing holes exact same side: 0.43" (11mm)
Width between installing holes opposite side: 1.2" (31mm)
Width of exhaust opening: 0.87" (22mm)
Height of exhaust opening: 0.17" (4.2mm)
Range between muffler installing holes 1.1" (28mm)
Crankshaft Thread Size: 1/4-28
Bore x Stroke: 16.8 x 13.6mm
Displacement: 0.18 cu in (3.01cc)
Optimum Power: 2.2PS/31,000 RPM

NEEDS
Fuel with 20%-25% Nitromethane and 18% (minimum) oil material

REMARKS:
The factory setting of the needle valves are as follows:
High speed needle: Flush with the carburetor body
Low Speed Needle: Flush with the carburetor body