HPI Nitro Star G3.0 High Output Engine, With Pullstart

This is the HPI Nitro Star G3.0 High Output Engine with Pull Beginner.

**Additional Technical Info Will be Included When It Appears.**

FUNCTIONS:
Finned black covered crankcase for extra strength and to assist cool the
    engine
Composite body slide valve carburetor with 7mm bore
2 year minimal service warranty beginning at date of purchase

INCLUDES:
G3.0 High Output Engine with Pull Beginner, Carburetor, R5 Cold Radiance
    Plug

NEEDS:
Fuel: Automobile blend with 20-25% nitro content
Track Devices: Glow starter, fuel tubing, radiance plug wrench

SPECIFICATIONS:
Displacement: .18 cu in (2.95cc)
Bore: 16.8mm
Stroke: 13.6mm
RPM: 30,000
Practical RPM: 6,500 - 32,000
Power: 2.2 ps/kw
Carburetor Settings:
High Speed Needle, 1-2/2 turns clockwise from flush
Idle Screw: Set throttle trim on transmitter so that throttle remains in
    neutral position, turn screw counter-clockwise to reduce idle
    speed, or clockwise to increase idle speed. Set idle speed high
    enough to keep engine running efficiently, however not high enough to
    engage the clutch.
Low Speed Needle: No change advised. For increased
    performance, set after high-speed needle is adjusted. Turn needle
    in 1/8 turn increments for much better bottom end throttle reaction.
    Caution-never turn in more than 2 turns from flush. This will
    cause engine to run too lean and will result in damage

Range Between Mounting Holes Exact same Side:
Range Between Mounting Holes Reverse Side:
Height Bottom of Installing Tabs to Top of Cylinder Head:
Width at Mounting Tabs:
Width of Crankcase Below Mounting Tabs:
Range from Front Bearing to End of Crankshaft:
Range from Pull Begin to Front Bearing:
Range from Center of Engine to Front Bearing:
Range from Center of Engine to Pull Start: