HPI Nitro Star G3.0 High Output Engine, With Pullstart

This is the HPI Nitro Star G3.0 High Output Engine with Pull Starter.

**Additional Technical Details Will be Added When It Becomes Available.**

FEATURES:
Finned black layered crankcase for extra strength and to assist cool the
    engine
Composite body slide valve carburetor with 7mm bore
2 year minimal warranty starting at date of purchase

INCLUDES:
G3.0 High Output Engine with Pull Starter, Carburetor, R5 Cold Radiance
    Plug

NEEDS:
Fuel: Vehicle mix with 20-25% nitro content
Track Devices: Glow starter, fuel tubing, glow plug wrench

SPECIFICATIONS:
Displacement: .18 cu in (2.95cc)
Bore: 16.8mm
Stroke: 13.6mm
RPM: 30,000
Practical RPM: 6,500 - 32,000
Power: 2.2 ps/kw
Carburetor Settings:
High Speed Needle, 1-2/2 turns clockwise from flush
Idle Screw: Set throttle trim on transmitter so that throttle remains in
    neutral position, turn screw counter-clockwise to reduce idle
    speed, or clockwise to increase idle speed. Set idle speed high
    enough to keep engine running smoothly, but not high enough to
    engage the clutch.
Low Speed Needle: No modification advised. For increased
    efficiency, set after high-speed needle is adjusted. Turn needle
    in 1/8 turn increments for better bottom end throttle reaction.
    Caution-never turn in more than 2 turns from flush. This will
    cause engine to run too lean and will lead to damage

Distance Between Mounting Holes Very same Side:
Distance Between Mounting Holes Opposite Side:
Height Bottom of Installing Tabs to Top of Cylinder Head:
Width at Mounting Tabs:
Width of Crankcase Below Mounting Tabs:
Distance from Front Bearing to End of Crankshaft:
Distance from Pull Start to Front Bearing:
Distance from Center of Engine to Front Bearing:
Distance from Center of Engine to Pull Start: