HPI Nitro Star G3.0 High Output Engine, With Pullstart

This is the HPI Nitro Star G3.0 High Output Engine with Pull Starter.

**Extra Technical Details Will be Included When It Appears.**

FEATURES:
Finned black coated crankcase for added strength and to help cool the
    engine
Composite body slide valve carburetor with 7mm bore
2 year minimal guarantee beginning at date of purchase

INCLUDES:
G3.0 High Output Engine with Pull Starter, Carburetor, R5 Cold Glow
    Plug

REQUIRES:
Fuel: Vehicle blend with 20-25% nitro material
Track Equipment: Shine starter, fuel tubing, radiance plug wrench

SPECIFICATIONS:
Displacement: .18 cu in (2.95cc)
Bore: 16.8mm
Stroke: 13.6mm
RPM: 30,000
Practical RPM: 6,500 - 32,000
Power: 2.2 ps/kw
Carburetor Settings:
High Speed Needle, 1-2/2 turns clockwise from flush
Idle Screw: Set throttle trim on transmitter so that throttle is in
    neutral position, turn screw counter-clockwise to reduce idle
    speed, or clockwise to increase idle speed. Set idle speed high
    enough to keep engine running smoothly, but not high enough to
    engage the clutch.
Low Speed Needle: No change advised. For increased
    efficiency, set after high-speed needle is adjusted. Turn needle
    in 1/8 turn increments for better bottom end throttle action.
    Caution-never turn in more than 2 turns from flush. This will
    cause engine to run too lean and will lead to damage

Range In between Mounting Holes Very same Side:
Range In between Mounting Holes Reverse Side:
Height Bottom of Installing Tabs to Top of Cylinder Head:
Width at Mounting Tabs:
Width of Crankcase Below Mounting Tabs:
Range from Front Bearing to End of Crankshaft:
Range from Pull Start to Front Bearing:
Range from Center of Engine to Front Bearing:
Range from Center of Engine to Pull Start: