HPI Nitro Star G3.0 High Output Engine, With Pullstart

This is the HPI Nitro Star G3.0 High Output Engine with Pull Starter.

**Extra Technical Info Will be Included When It Appears.**

FEATURES:
Finned black covered crankcase for extra strength and to help cool the
    engine
Composite body slide valve carburetor with 7mm bore
Two year restricted warranty starting at date of purchase

INCLUDES:
G3.0 High Output Engine with Pull Starter, Carburetor, R5 Cold Radiance
    Plug

NEEDS:
Fuel: Car blend with 20-25% nitro content
Track Equipment: Glow starter, fuel tubing, radiance plug wrench

SPECIFICATIONS:
Displacement: .18 cu in (2.95cc)
Bore: 16.8mm
Stroke: 13.6mm
RPM: 30,000
Practical RPM: 6,500 - 32,000
Power: 2.2 ps/kw
Carburetor Settings:
High Speed Needle, 1-2/2 turns clockwise from flush
Idle Screw: Set throttle trim on transmitter so that throttle is in
    neutral position, turn screw counter-clockwise to decrease idle
    speed, or clockwise to increase idle speed. Set idle speed high
    enough to keep engine running efficiently, but low enough to
    engage the clutch.
Low Speed Needle: No adjustment suggested. For increased
    performance, set after high-speed needle is adjusted. Turn needle
    in 1/8 turn increments for better bottom end throttle reaction.
    Caution-never turn in more than 2 turns from flush. This will
    cause engine to run too lean and will result in damage

Distance Between Mounting Holes Exact same Side:
Distance Between Mounting Holes Reverse Side:
Height Bottom of Installing Tabs to Top of Cylinder Head:
Width at Mounting Tabs:
Width of Crankcase Below Mounting Tabs:
Distance from Front Bearing to End of Crankshaft:
Distance from Pull Begin to Front Bearing:
Distance from Center of Engine to Front Bearing:
Distance from Center of Engine to Pull Start: