HPI Nitro Star G3.0 High Output Engine, With Pullstart

This is the HPI Nitro Star G3.0 High Output Engine with Pull Beginner.

**Additional Technical Information Will be Included When It Becomes Available.**

FUNCTIONS:
Finned black covered crankcase for extra strength and to assist cool the
    engine
Composite body slide valve carburetor with 7mm bore
Two year restricted warranty beginning at date of purchase

CONSISTS OF:
G3.0 High Output Engine with Pull Beginner, Carburetor, R5 Cold Glow
    Plug

REQUIRES:
Fuel: Vehicle blend with 20-25% nitro content
Track Equipment: Shine starter, fuel tubing, glow plug wrench

SPECS:
Displacement: .18 cu in (2.95cc)
Bore: 16.8mm
Stroke: 13.6mm
RPM: 30,000
Practical RPM: 6,500 - 32,000
Power: 2.2 ps/kw
Carburetor Settings:
High Speed Needle, 1-2/2 turns clockwise from flush
Idle Screw: Set throttle trim on transmitter so that throttle is in
    neutral position, turn screw counter-clockwise to lower idle
    speed, or clockwise to increase idle speed. Set idle speed high
    enough to keep engine running smoothly, but not high enough to
    engage the clutch.
Low Speed Needle: No modification recommended. For increased
    efficiency, set after high-speed needle is changed. Turn needle
    in 1/8 turn increments for better bottom end throttle response.
    Caution-never turn in more than 2 turns from flush. This will
    cause engine to run too lean and will lead to damage

Range Between Mounting Holes Very same Side:
Range Between Mounting Holes Opposite Side:
Height Bottom of Installing Tabs to Top of Cylinder Head:
Width at Mounting Tabs:
Width of Crankcase Below Mounting Tabs:
Range from Front Bearing to End of Crankshaft:
Range from Pull Begin to Front Bearing:
Range from Center of Engine to Front Bearing:
Range from Center of Engine to Pull Start: