HPI Nitro Star G3.0 High Output Engine, With Pullstart

This is the HPI Nitro Star G3.0 High Output Engine with Pull Beginner.

**Additional Technical Details Will be Added When It Appears.**

FUNCTIONS:
Finned black layered crankcase for additional strength and to help cool the
    engine
Composite body slide valve carburetor with 7mm bore
2 year limited warranty beginning at date of purchase

CONSISTS OF:
G3.0 High Output Engine with Pull Beginner, Carburetor, R5 Cold Glow
    Plug

NEEDS:
Fuel: Vehicle blend with 20-25% nitro material
Track Equipment: Shine starter, fuel tubing, radiance plug wrench

SPECS:
Displacement: .18 cu in (2.95cc)
Bore: 16.8mm
Stroke: 13.6mm
RPM: 30,000
Practical RPM: 6,500 - 32,000
Power: 2.2 ps/kw
Carburetor Settings:
High Speed Needle, 1-2/2 turns clockwise from flush
Idle Screw: Set throttle trim on transmitter so that throttle remains in
    neutral position, turn screw counter-clockwise to minimize idle
    speed, or clockwise to increase idle speed. Set idle speed high
    enough to keep engine running smoothly, but low enough to
    engage the clutch.
Low Speed Needle: No adjustment suggested. For increased
    efficiency, set after high-speed needle is changed. Turn needle
    in 1/8 turn increments for much better bottom end throttle action.
    Caution-never turn in more than 2 turns from flush. This will
    cause engine to run too lean and will result in damage

Distance Between Mounting Holes Exact same Side:
Distance Between Mounting Holes Opposite Side:
Height Bottom of Installing Tabs to Top of Cylinder Head:
Width at Mounting Tabs:
Width of Crankcase Below Mounting Tabs:
Distance from Front Bearing to End of Crankshaft:
Distance from Pull Begin to Front Bearing:
Distance from Center of Engine to Front Bearing:
Distance from Center of Engine to Pull Start: