HPI Nitro Star G3.0 High Output Engine, With Pullstart

This is the HPI Nitro Star G3.0 High Output Engine with Pull Beginner.

**Extra Technical Information Will be Included When It Appears.**

FEATURES:
Finned black coated crankcase for extra strength and to help cool the
    engine
Composite body slide valve carburetor with 7mm bore
Two year restricted service warranty starting at date of purchase

INCLUDES:
G3.0 High Output Engine with Pull Beginner, Carburetor, R5 Cold Radiance
    Plug

NEEDS:
Fuel: Cars and truck mix with 20-25% nitro material
Track Equipment: Glow starter, fuel tubing, glow plug wrench

SPECS:
Displacement: .18 cu in (2.95cc)
Bore: 16.8mm
Stroke: 13.6mm
RPM: 30,000
Practical RPM: 6,500 - 32,000
Power: 2.2 ps/kw
Carburetor Settings:
High Speed Needle, 1-2/2 turns clockwise from flush
Idle Screw: Set throttle trim on transmitter so that throttle remains in
    neutral position, turn screw counter-clockwise to decrease idle
    speed, or clockwise to increase idle speed. Set idle speed high
    enough to keep engine running efficiently, however low enough to
    engage the clutch.
Low Speed Needle: No adjustment recommended. For increased
    efficiency, set after high-speed needle is changed. Turn needle
    in 1/8 turn increments for better bottom end throttle reaction.
    Caution-never turn in more than 2 turns from flush. This will
    cause engine to run too lean and will lead to damage

Range Between Mounting Holes Exact same Side:
Range Between Mounting Holes Opposite Side:
Height Bottom of Mounting Tabs to Top of Cylinder Head:
Width at Mounting Tabs:
Width of Crankcase Below Mounting Tabs:
Range from Front Bearing to End of Crankshaft:
Range from Pull Start to Front Bearing:
Range from Center of Engine to Front Bearing:
Range from Center of Engine to Pull Start: