JavaScript seems to be disabled in your browser.

You must have JavaScript enabled in your browser to utilize the functionality of this website. Click here for instructions on enabling javascript in your browser.

HPI Nitro Star F4.6 V2 Engine, 4.6Cc, Slide Carburettor, And Rear Ex (HPI 111595 | HPI111595)

Model: HPI 111595
Dist. #: HPIG1595   SKU: HPI111595

Be the first to review this product. (Write Review)

Out of stock

List Price:  $188.99
Price:  $170.09
You Save:  $18.9 (10%)

This item will earn you 170 reward point(s).
170 points = $3.40 off your next order. Learn More

Updated on Mar 28, 2024 03:13:05 PM

Nitro Star F4.6 V2 Engine w/PS...
This is the HPI Nitro Star F4.6 V2 Monster Truck Engine with Pull Starter.

FEATURES:
Fits any HPI Savage or other 1/8 scale beast truck
1.3oz (37g) lighter and 0.47" (12mm) shorter than previous version
Larger fins on cylinder head for improved cooling
New pull starter usages one-way bearing encased in a large 14mm hex for
    increased sturdiness
Composite body slide valve F1 7.5mm carburetor
8 ports, 7 intake, one exhaust
2 year limited warranty begining at date of purchase, Valid only
    on engines offered and used in the U.S.A, Canada, and South America

INCLUDES:
F4.6 V2 Monster Truck Engine with Pull Starter, Cold R5 Glow Plug,
    Air Filter, and Directions

REQUIRES:
Glow Fuel: 15-25% cars and truck blend, 20% needed for break-in
Air filter oil
Glow starter and track equipment
SPECS:
Displacement: 4.6cc
Bore: 18.68mm
Stroke: 16.6mm
Power: 2.9hp @ 32,000RPM
Range between Mounting Hole Centers/Same Side: 083" (21mm)
Range between Mounting Hole Centers/Opposite Side: 1.46" (37.2mm)
Crankcase Width listed below Installing Tabs: 1.25" (32mm)
Width at Installing Tabs: 1.8" (46mm)
Height/bottom of Mounting Tab/top of Cylinder Head: 3.5" (88mm)
Height/bottom of Crankcase/top of Cylinder Head: 4" (102mm)
Length/Pull Starter to Front Bearing: 3.3" (84mm)
Length/Pull Starter to end of Crankshaft: 4.5" (114mm)

Carburetor Settings:
    High Speed Needle, 2-2/2 turns clockwise from flush
    Idle Screw: Set throttle trim on transmitter so that throttle is in
neutral position, turn screw counter-clockwise to lower idle
speed, or clockwise to increase idle speed. Set idle speed high
enough to keep engine running efficiently, however low enough to
engage the clutch.
    Low Speed Needle: No adjustment advised. For increased
performance, set after high-speed needle is adjusted. Turn needle
in 1/8 turn increments for much better bottom end throttle response.
Caution-never turn in more than 2 turns from flush. This will
cause engine to run too lean and will lead to damage.

NOTES:
The front bearing is 19x7x6, the rear bearing is 25x14x6 jxs 10/23/14
Visual Parts Finder
What's New?
";