HPI Nitro Star F3.5 V2 Engine, 3.5Cc, Slide Carburettor, And Rear Ex

This is the HPI Nitro Star F3.5 V2 Engine with Pull Starter.

FEATURES:
ABC construction, "A"luminum piston with "B"rass liner that is
    "C"hrome plated
Slide valve 2-needle carburetor with composite body that lowers
    heat transfer and helps prevent vaporization of fuel
Race legal .21 cu in (3.5cc) displacement
22g lighter and 4mm taller than previous version
Two phase air filter with splash cover
Pull starter with one-way bearing enclosed in a 14mm hex for increased
    resilience
Two year restricted guarantee starting at date of purchase

INCLUDES:
Nitro Star F3.5 V2 Engine with Pull Beginner, R5 Glow Plug, Air Filter
    and Guidelines

NEEDS:
Glow Fuel: Automobile blend with 20-25% nitro material, utilize 20% for break-
    in
Air filter oil

SPECIFICATIONS:
Displacement: .21 cu in (3.5cc)
Carburetor Settings:
    High Speed Needle, 2-2/2 turns clockwise from flush
    Idle Screw: Set throttle trim on transmitter so that throttle remains in
neutral position, turn screw counter-clockwise to decrease idle
speed, or clockwise to increase idle speed. Set idle speed high
enough to keep engine running smoothly, however not high enough to
engage the clutch.
    Low Speed Needle: No change recommended. For increased
efficiency, set after high-speed needle is changed. Turn needle
in 1/8 turn increments for much better bottom end throttle response.
Caution-never turn in more than 2 turns from flush. This will
trigger engine to run too lean and will lead to damage.