HPI Flux Emh-3S Brushless Esc, Use W/ Flux Mmh-4000Kv Brushless Moto

This is the HPI Flux EMH-3S Electronic Speed Control for Brushless Motors.
Handles bigger motors and greater capacity battery loads
than the Flux Reload V2 it replaces.
Used in the HPI RTR Bullet ST Flux, and the RTR Blitz Flux.

FEATURES:
Suitable for any brushless powered 1/10 scale on or off-road car, truck
    or buggy
Dustproof and water resistant
3 running modes;
    Racing (Forward and Brake only)
    Bashing (Forward, Brake and Reverse)
    Rock Crawler (instantaneous switch from Forward to Reverse)
8 action Drag Brake modification from 0-100%
6 Car LiPo Cut Off settings; none or 2.5-3.4V per cell
9 punch start mode settings from soft to aggressive
4 steps of Optimum Brake Force Adjustment from 25-100%
4 steps of Optimum Reverse Force modification from 25-100%
3 steps of Preliminary Brake Force modification from 0-40%, plus
    option to make IBF equal drag brake setting
3 steps of Neutral Range modification from 6-12%
8 steps of Motor Timing modification from 0-26.25 degrees
Overheat protection
Several protection, Car LiPo Security, Low Voltage Cutoff,
    Throttle Signal Loss
Suitable with the #101280 2 in 1 Program Card, not included-must
    purchase independently

INCLUDES:
Flux EMH-3S ESC with Dean's Ultra Male Battery Adapter, Bullet
    Motor Connectors, On/Off Change, Receiver Adapter, Cooling Fan,
    and Instructions

SPECIFICATIONS:
Continuous Existing: 80A - Reload V2 was 60A
Burst Current: 540A - Reload V2 was 190A
Resistance: 0.0004 ohm
Battery Limit: 4-9 Cells NiMH or 2-3S LiPo
Motor Limit:
2S LiPo or 6 Cell NiMH: On-Road 5.5T, Off-Road 6000 kV
3S LiPo or 9 Cell NiMH: On-Road 8.5T, Off-Road 4000 kV
BEC: 6V/2A
Motor Type: Sensorless Brushless
Dimensions: 2.0 x 2.2 x 1.4" (50.5 x 56.2 x 35.4mm)