HPI Flux Emh-3S Brushless Esc, Use W/ Flux Mmh-4000Kv Brushless Moto

This is the HPI Flux EMH-3S Electronic Speed Control for Brushless Motors.
Handles larger motors and higher capacity battery packs
than the Flux Reload V2 it replaces.
Used in the HPI RTR Bullet ST Flux, and the RTR Blitz Flux.

FEATURES:
Perfect for any brushless powered 1/10 scale on or off-road automobile, truck
    or buggy
Dustproof and water resistant
3 running modes;
    Racing (Forward and Brake only)
    Slamming (Forward, Brake and Reverse)
    Rock Spider (immediate switch from Forward to Reverse)
8 action Drag Brake adjustment from 0-100%
6 Auto LiPo Cut Off settings; none or 2.5-3.4V per cell
Nine punch start mode settings from soft to aggressive
Four actions of Maximum Brake Force Change from 25-100%
Four actions of Maximum Reverse Force adjustment from 25-100%
3 actions of Preliminary Brake Force adjustment from 0-40%, plus
    alternative to make IBF equal drag brake setting
3 actions of Neutral Variety adjustment from 6-12%
8 actions of Motor Timing adjustment from 0-26.25 degrees
Overheat protection
Several protection, Auto LiPo Security, Low Voltage Cutoff,
    Throttle Signal Loss
Suitable with the #101280 2 in 1 Program Card, not included-must
    purchase independently

CONSISTS OF:
Flux EMH-3S ESC with Dean's Ultra Male Battery Adapter, Bullet
    Motor Connectors, On/Off Switch, Receiver Adapter, Cooling Fan,
    and Guidelines

SPECS:
Continuous Present: 80A - Reload V2 was 60A
Burst Current: 540A - Reload V2 was 190A
Resistance: 0.0004 ohm
Battery Limitation: 4-9 Cells NiMH or 2-3S LiPo
Motor Limitation:
2S LiPo or 6 Cell NiMH: On-Road 5.5T, Off-Road 6000 kV
3S LiPo or 9 Cell NiMH: On-Road 8.5T, Off-Road 4000 kV
BEC: 6V/2A
Motor Type: Sensorless Brushless
Dimensions: 2.0 x 2.2 x 1.4" (50.5 x 56.2 x 35.4mm)