HPI Flux Emh-3S Brushless Esc, Use W/ Flux Mmh-4000Kv Brushless Moto

This is the HPI Flux EMH-3S Electronic Speed Control for Brushless Motors.
Handles larger motors and higher capacity battery loads
than the Flux Reload V2 it replaces.
Used in the HPI RTR Bullet ST Flux, and the RTR Blitz Flux.

FEATURES:
Suitable for any brushless powered 1/10 scale on or off-road vehicle, truck
    or buggy
Dustproof and waterproof
Three running modes;
    Racing (Forward and Brake just)
    Slamming (Forward, Brake and Reverse)
    Rock Spider (instant switch from Forward to Reverse)
Eight step Drag Brake modification from 0-100%
6 Vehicle LiPo Cut Off settings; none or 2.5-3.4V per cell
Nine punch start mode settings from soft to aggressive
Four steps of Optimum Brake Force Modification from 25-100%
Four steps of Optimum Reverse Force modification from 25-100%
Three steps of Initial Brake Force modification from 0-40%, plus
    option to make IBF equal drag brake setting
Three steps of Neutral Range modification from 6-12%
Eight steps of Motor Timing modification from 0-26.25 degrees
Overheat defense
Numerous defense, Vehicle LiPo Security, Low Voltage Cutoff,
    Throttle Signal Loss
Compatible with the #101280 2 in 1 Program Card, not included-must
    purchase individually

INCLUDES:
Flux EMH-3S ESC with Dean's Ultra Male Battery Port, Bullet
    Motor Connectors, On/Off Switch, Receiver Port, Cooling Fan,
    and Directions

SPECIFICATIONS:
Continuous Current: 80A - Reload V2 was 60A
Burst Current: 540A - Reload V2 was 190A
Resistance: 0.0004 ohm
Battery Limit: 4-9 Cells NiMH or 2-3S LiPo
Motor Limit:
2S LiPo or 6 Cell NiMH: On-Road 5.5T, Off-Road 6000 kV
THREE LiPo or 9 Cell NiMH: On-Road 8.5T, Off-Road 4000 kV
BEC: 6V/2A
Motor Type: Sensorless Brushless
Dimensions: 2.0 x 2.2 x 1.4" (50.5 x 56.2 x 35.4mm)