HPI Flux Emh-3S Brushless Esc, Use W/ Flux Mmh-4000Kv Brushless Moto

This is the HPI Flux EMH-3S Electronic Speed Control for Brushless Motors.
Handles larger motors and greater capacity battery loads
than the Flux Reload V2 it replaces.
Used in the HPI RTR Bullet ST Flux, and the RTR Blitz Flux.

FEATURES:
Perfect for any brushless powered 1/10 scale on or off-road automobile, truck
    or buggy
Dustproof and waterproof
Three running modes;
    Racing (Forward and Brake just)
    Bashing (Forward, Brake and Reverse)
    Rock Crawler (immediate switch from Forward to Reverse)
Eight action Drag Brake change from 0-100%
6 Car LiPo Cut Off settings; none or 2.5-3.4V per cell
Nine punch start mode settings from soft to aggressive
Four steps of Maximum Brake Force Adjustment from 25-100%
Four steps of Maximum Reverse Force change from 25-100%
Three steps of Preliminary Brake Force change from 0-40%, plus
    option to make IBF equivalent drag brake setting
Three steps of Neutral Variety change from 6-12%
Eight steps of Motor Timing change from 0-26.25 degrees
Overheat protection
Several protection, Car LiPo Security, Low Voltage Cutoff,
    Throttle Signal Loss
Suitable with the #101280 2 in 1 Program Card, not included-must
    purchase independently

INCLUDES:
Flux EMH-3S ESC with Dean's Ultra Male Battery Adapter, Bullet
    Motor Connectors, On/Off Change, Receiver Adapter, Cooling Fan,
    and Directions

SPECS:
Continuous Existing: 80A - Reload V2 was 60A
Burst Current: 540A - Reload V2 was 190A
Resistance: 0.0004 ohm
Battery Limit: 4-9 Cells NiMH or 2-3S LiPo
Motor Limit:
2S LiPo or 6 Cell NiMH: On-Road 5.5T, Off-Road 6000 kV
3S LiPo or 9 Cell NiMH: On-Road 8.5T, Off-Road 4000 kV
BEC: 6V/2A
Motor Type: Sensorless Brushless
Dimensions: 2.0 x 2.2 x 1.4" (50.5 x 56.2 x 35.4mm)