HPI Flux Emh-3S Brushless Esc, Use W/ Flux Mmh-4000Kv Brushless Moto

This is the HPI Flux EMH-3S Electronic Speed Control for Brushless Motors.
Handles larger motors and greater capability battery loads
than the Flux Reload V2 it replaces.
Used in the HPI RTR Bullet ST Flux, and the RTR Blitz Flux.

FEATURES:
Ideal for any brushless powered 1/10 scale on or off-road automobile, truck
    or buggy
Dustproof and waterproof
Three running modes;
    Racing (Forward and Brake only)
    Slamming (Forward, Brake and Reverse)
    Rock Spider (instant switch from Forward to Reverse)
Eight step Drag Brake change from 0-100%
Six Automobile LiPo Cut Off settings; none or 2.5-3.4V per cell
Nine punch start mode settings from soft to aggressive
4 actions of Maximum Brake Force Adjustment from 25-100%
4 actions of Maximum Reverse Force change from 25-100%
Three actions of Initial Brake Force change from 0-40%, plus
    alternative to make IBF equal drag brake setting
Three actions of Neutral Variety change from 6-12%
Eight actions of Motor Timing change from 0-26.25 degrees
Overheat defense
Several defense, Automobile LiPo Defense, Low Voltage Cutoff,
    Throttle Signal Loss
Compatible with the #101280 2 in 1 Program Card, not included-must
    purchase individually

CONSISTS OF:
Flux EMH-3S ESC with Dean's Ultra Male Battery Adapter, Bullet
    Motor Connectors, On/Off Change, Receiver Adapter, Cooling Fan,
    and Instructions

SPECS:
Continuous Current: 80A - Reload V2 was 60A
Burst Current: 540A - Reload V2 was 190A
Resistance: 0.0004 ohm
Battery Limitation: 4-9 Cells NiMH or 2-3S LiPo
Motor Limitation:
2S LiPo or 6 Cell NiMH: On-Road 5.5T, Off-Road 6000 kV
THREE LiPo or 9 Cell NiMH: On-Road 8.5T, Off-Road 4000 kV
BEC: 6V/2A
Motor Type: Sensorless Brushless
Dimensions: 2.0 x 2.2 x 1.4" (50.5 x 56.2 x 35.4mm)