HPI Differential Gear Set, Bullet Mt/St

This is the Diff Gear Set
For the HPI Racing WRI and Bullet Series

FEATURES:
Steel building and construction
Fits the WR8 Flux, Bullet MT and ST Flux, Bullet MT and ST Nitro
Also fits all 3 gearboxes of the D413 Buggy Package from Hot Bodies

CONSISTS OF:
Two big bevel gears
4 little bevel gears

COMMENTS:
This differential gear set can be installed on
1/8 WR8 3.0 Ford Carnival Rally Abu Dhabi RTR
1/10 Bullet MT Flux 2.4GHz RTR
1/10 Bullet ST Flux 2.4GHz RTR
1/10 Bullet MT 3.0 Nitro 2.4GHz RTR
1/10 Bullet ST 3.0 Nitro 2.4GHz RTR

This product compliments the above reviewed product.



This is the Venom 7.4V 5000mAh 40C Hardcase LiPo Battery Load with
the Venom Universal Plug System.

FEATURES:
Wired for balancing
Venom Universal 4 Plug System permits connectivity in between today's
    four most typical battery plugs, Tamiya, Traxxas, Deans and EC3,
    just attach wanted plug to Venom plug on battery's wire leads

CONSISTS OF:
7.4V 5000mAh 40C Hardcase LiPo Battery Load with Tamiya, Traxxas,
    Deans and EC3 Plugs

REQUIRES:
LiPo capable battery charger such as the DuraTrax Onyx series
Charge Lead Banana Plugs with Deans Ultra Male (DTXC2221) if using
    Duratrax Onyx series
LiPo Balancer such as the Team Checkpoint Pro Car balancer (TCPP9150)

SPECIFICATIONS:
Setup: TWO
Weight: 277g (9.8oz)
Measurements: 25 x 46.5 x 137.5mm (0.98" x 1.8" x 5.4")
Charge Rate: 3C (15A)
Continuous Discharge 40C (200A)
Minutes Discharge Volts Per Load: 6.0V
Max Burst Rate: 80C (400A)
Max Volts Per Cell: 4.2V
Max Volts Per Load: 8.4V

COMMENTS:
CHECK OUT the ENTIRE guideline sheet included with battery before use
ALWAYS utilize a LiPo-approved Battery charger
ALWAYS utilize a LiPo Cell Balancer
NEVER Charge over 4.2V per cell
NEVER Charge at currents higher than 1C
NEVER Charge through the "To ESC or "RELEASE" lead
NEVER Trickle Charge
NEVER enable to Discharge listed below 2.5V per cell
NEVER take apart or customize pack electrical wiring in any manner in which or puncture cells
NEVER place on combustible products or leave unattended throughout
charging
ALWAYS charge in a fire-resistant area
ALWAYS set battery charger's output volts to match battery volts
CONSTANTLY keep out of reach of children

You will certainly enjoy this thing if you have the thing earlier pointed out.

Differential Case, 5X25x16.5Mm, Bullet Mt/St

This is the 5 x 25 x 16.5mm Diff Case for the HPI Savage XS and Bullet.

FEATURES:
Molded plastic building and construction

CONSISTS OF:
Differential Case

Get this product to boost the one you are reading about.

Slipper Clutch Spring, 7X9x1.7Mm, 3 Coils, Bullet Mt/St

This is the Slipper Clutch Spring 7x9x1.7mm 3 Coils
For the HPI Racing Bullet Series

FEATURES:
Black colored steel building and construction

CONSISTS OF:
One spring

COMMENTS:
The HPI Racing Bullet Series includes
Bullet ST Flux 2.4GHz RTR (HPID7008)
Bullet MT Flux 2.4GHz RTR (HPID7010)
Bullet ST 3.0 Nitro 2.4GHz RTR (HPID7004)
Bullet MT 3.0 Nitro 2.4GHz RTR (HPID7006)