Hot Racing Brass 88G Currie F9 Portal Axle 3Rd Member, For Axial Utb

Brass 88g Currie F9 Portal Axle 3rd Member, for Axial UTB

Features:

CNC machined strong brass billet

Stronger and stiffer than the stock 3rd member, for a better gear mesh and more trustworthy performance

Adds 88g of low and main weight to lower and centralize the vehicle's center of mass, increase its stability, and make it an

overall more capable spider

Direct fit onto Axial Front or rear UTB Currie F9 axle

Replaces plastic 3rd member from AXI232004

This product compliments the above reviewed product.

Brass Currie F9 Portal Steering Knuckle Caps UTB

The below product also sets truly well with the product being reviewed.



Brass Currie F9 Portal Steering Knuckle, for Axial UTB & SCX 3

Hot Racing heavy duty brass steering knuckles (steering blocks) for the Axial UTB Currie F9 and Scx 3 Portal axles. Add weight to your spider where it needs it - down low. Adds about 95g (3.36oz) to each side.

Included:

- 2 (2) brass steering knuckles

Requirements:

- Suggested to use a removable-type locking adhesive on screws threading into metal.

Features:

CNC machined strong brass

Heavy to add weight to vehicle for greater stability and lower CG

High strength steel hardware

Direct replacement for factory plastic steering knuckles

Replaces factory plastic Axial 232006 steering knuckles AXI232006

Specs:

Height: 52 mm

Width 40mm

Weight 95g (3.6oz) each

This is a amazing addition to the product currently being reviewed.



These are the Axial 2.2 Beadlock Wheels in Black.

FEATURES:
8 hole design, built of incredibly strong composite material
Gray aluminum ring
Fits 12mm hex hubs
True beadlock design, no untidy gluing needed
2x10mm socket head cap screws (12 screws per wheel)

INCLUDES:
2 Axial 2.2 Beadlock Wheels in Black with ring installing hardware

NEEDS:
Tires of modeler's choice

SPECS:
Width: 1.4" (36mm)
Beadlock Size: 2.2" (55.5mm)
Hex Size: 0.47" (12mm)

Get this product to improve the one you are reading around.

Aluminum Servo Horn 25T

This is the Axial 25T Aluminum Servo Horn for Futaba, Axial and Savox Servos.

FEATURES:
Difficult anodized aluminum building and construction
Compression install, two screws install on either side of arm and
    tighten up center hole around servo spline

INCLUDES:
Axial 25T Aluminum Servo Horn
2 2x8mm socket head screws

SPECS:
Length: 0.98" (25mm) from center of servo installing hole to end of arm
Hole Size: 3mm
Pitch:3x30