Hot Racing Brass 88G Currie F9 Portal Axle 3Rd Member, For Axial Utb

Brass 88g Currie F9 Portal Axle 3rd Member, for Axial UTB

Functions:

CNC machined solid brass billet

Stronger and stiffer than the stock 3rd member, for a better equipment mesh and more trustworthy efficiency

Includes 88g of low and main weight to lower and centralize the vehicle's center of mass, increase its stability, and make it an

in general more capable crawler

Direct fit onto Axial Front or rear UTB Currie F9 axle

Changes plastic 3rd member from AXI232004

This item praises the above gone over item.

Brass Currie F9 Portal Steering Knuckle Caps UTB

The below item also sets truly well with the item being gone over.



Brass Currie F9 Portal Steering Knuckle, for Axial UTB & SCX 3

Hot Racing sturdy brass steering knuckles (steering blocks) for the Axial UTB Currie F9 and Scx 3 Portal axles. Include weight to your crawler where it requires it - down low. Includes about 95g (3.36oz) to each side.

Included:

- Two (2) brass steering knuckles

Requirements:

- Suggested to use a removable-type locking adhesive on screws threading into metal.

Features:

CNC machined solid brass

Heavy to include weight to vehicle for higher stability and lower CG

High strength steel hardware

Direct replacement for factory plastic steering knuckles

Changes factory plastic Axial 232006 steering knuckles AXI232006

Specs:

Height: 52 mm

Width 40mm

Weight 95g (3.6oz) each

This is a amazing enhancement to the item currently being gone over.



These are the Axial 2.2 Beadlock Wheels in Black.

FEATURES:
Eight hole style, built of super strong composite product
Gray aluminum ring
Fits 12mm hex centers
True beadlock style, no untidy gluing needed
2x10mm socket head cap screws (12 screws per wheel)

INCLUDES:
Two Axial 2.2 Beadlock Wheels in Black with ring mounting hardware

NEEDS:
Tires of modeler's choice

SPECS:
Width: 1.4" (36mm)
Beadlock Diameter: 2.2" (55.5mm)
Hex Size: 0.47" (12mm)

Get this item to enhance the one you are reading about.

Aluminum Servo Horn 25T

This is the Axial 25T Aluminum Servo Horn for Futaba, Axial and Savox Servos.

FEATURES:
Tough anodized aluminum construction
Compression install, 2 screws set up on either side of arm and
    tighten up center hole around servo spline

INCLUDES:
Axial 25T Aluminum Servo Horn
Two 2x8mm socket head screws

SPECS:
Length: 0.98" (25mm) from center of servo mounting hole to end of arm
Hole Diameter: 3mm
Pitch:3x30