Holmes Hobby SHV800 Servo

The SHV800 is an unbelievable 800 to 1300oz/in servo designed for the high impact punishment of R/C Rock Crawlers and Rock Racers, however is at home in any car that requires high torque, ultra fast speeds, and enormous gear strength! It can be powered straight by a 2s to 4S LiPo battery by means of JST connection and does not require a BEC! Tidy up your electrical wiring, gain space in a tight rig, and delight in enormous efficiency at industry leading high effectiveness from the high quality brushless motor and circuitry.

FEATURES:

Full aluminum Case with O-Ring Seals

All steel machined equipments with industry leading pin strength

Extra-large Brushless motor with 200C ranked Neodymium magnets

24cm radio signal lead

24cm power lead with female JST plug, includes male extension

120 degree rotation

1 Year Service warranty

SPECS:

Weight: 94g

Measurements: 38.7x20x40mm

Spline: 25 tooth (Futaba type) M3 threaded

Torque @ 8.4v & 4 amp: 790 oz/inch (57kg/cm)

Speed @ 8.4v: 0.18 sec

Torque @ 12v & 4.1 amp: 1050 oz/inch (75kg/cm)

Speed @ 12v: 0.12 sec

Torque @ 15v & 5.1 amp: 1290 oz/inch (93kg/com)

Speed @ 15v: 0.10 sec

You need to utilize a radio with endpoint adjustment for correct installation.  The battery needs to be disconnected from the ESC AND servo when not in use to avoid damage to the servo and/or battery. Do not power the servo straight from a battery balance port. Doing so can damage the servo and will void the service warranty. Moly (marine) grease is suggested when oiling the equipments. Dielectric grease is suggested on the power board and potentiometer if looking to increase water resistance.