Great Planes Rimfire Prop Saver 28mm Motors

This is the ElectriFly Rimfire Prop Saver for usage on 28mm Motors.

FEATURES:
Aluminum construction

CONSISTS OF:
One Prop Saver
2 Rubber O-Rings
2 Bushings

NEEDS:
Installation on Rimfire 28mm Motor

Right here is a fantastic thing that several others have actually bought at the same time.

Tower Pro SG90 Servo

Functions:
Micro Servo Titan 9g servo
Gear Type : All Nylon Gear
Dead Band Width : 2 usec
Stall Torque : 1.5kg/cm at 4.8V
Operation Voltage : 3.0 - 7.2Volts

Requirements:
Measurement : 23mm x 12mm x 29mm
Adapter Wire Length : About 248mm
Operating Speed : 0.12sec / 60 degrees (4.8V no load)
Temperature Variety : -30 to +60 Degree C
Net weight : about 11g
Color : black

Packing content:
1 x 9g TITAN Servo Sets (with accessories)

This thing praises the above talked about thing.

930Kv Brushless Outrunner Motor, 3.17 MM Shaft, 3.5MM Bullet Con

LI-Poly Cell:2-3
Ni-MH Cells: 6-10
RPM/V: 1800Kv
Max. effectiveness existing: 6-10 Amp
NoLoad current / 10 V: 0.8 Amp
Present capability: 16 A/60 s
Max. Efficiency: 74%
Shaft size: 3mm

A2208-12 similar to: AXI 2208/20, E-Flite Park 370

This thing praises the main item below.

6x4 Thin Electric Prop

This is a 6x4E Thin Composite propeller from Advanced Accuracy Composites.
For utilize on Electric powered airplane just (not for radiance engines).

FUNCTIONS:
Gray composite propeller blades that put together onto a propeller hub.
Comes with 2 adjuster rings that adapt to various motor shafts.
Comes in a bag connected to a header card.

INCLUDES:
One composite propeller
2 composite adapter rings
One instruction sheet

NEEDS:
Assembly onto motor or equipment drive unit in your Electric plane.
Balancing

SPECIFICATIONS:
Diameter: 6"
Pitch: 4
Center inner size: 0.25"

COMMENTS:
Usage Speed 400 Electric motors.

Right here is a fantastic thing that several others have actually bought at the same time.

8x3.8 Slow Flyer Propeller

This is a 8x3.8 Slo-Flyer "tractor" (not a "pusher") plane propeller.
This prop produces a lot of torque even at low speeds.

FEATURES:
Computer-optimized design provides these props a thinner profile and
    more "bite" with less noise.
Lightweight formed nylon construction reduces rotating mass for
    greater output and longer life.
Reinforcing carbon fibers assist keep real, constant pitch at
    any rpm.
Slo-Flyer propellers work well with Electric powered Park Flyer-type
    aircraft.

INCLUDES:
One carbon-reinforced nylon propeller
One set of little shaft finding rings
One finding ring instruction sheet

NEEDS:
ALL props need balancing (usage TOPQ5700)
May need prop reamer, usage GPMQ5005 (SAE) or GPMQ5007 (Metric)

SPECIFICATIONS:
Length: 8"
Pitch: 3.8

COMMENTS:
Slo-Flyer props are Not created for Glow engines

Right here is one more thing that praises the thing being talked about.

7x6E Thin Electric

This is a 7x6EP Thin Propeller from Advanced Accuracy Composites.
For utilize on electric powered airplane just (not for radiance engines).

FUNCTIONS:
Gray composite construction
Comes with 2 adjuster rings that adapt to various motor shafts

CONSISTS OF:
One 7x6EP Thin Electric Propeller

NEEDS:
ALL props need balancing, this is VERY vital, utilize TOPQ5700.
May requirement prop reamer, usage GPMQ5005 (SAE) or GPMQ5007 (Metric)

SPECIFICATIONS:
Diameter: 7"
Pitch: 6
Center inner size: 0.25" (6.3mm)