E-Flite 60-Amp Pro Switch-Mode BEC Brushless ESC (V2)

The E-flite® 60-Amp Pro Switch-Mode BEC Brushless ESC (V2). This is a top quality sensorless brushless electronic speed control with an integrated switch-mode BEC that is really lightweight and efficient. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication.

Features
Approximately 60 amps constant existing with correct air flow and 75 amps burst existing (15 seconds)
5A constant existing, 5V switch-mode BEC circuit (correct cooling and air flow required)
More powerful BEC for support of many 3-axis stabilization systems
Increase to 7 analog or 6 digital standard-sized servos with the BEC on any recommended input voltage
3- to 6-cell Li-Po, 9- to 18-cell Ni-MH/Ni-Cd input voltage
Finned heat sinks
Programmable motor braking
Safe power-arm mode avoids unexpected starts
Programmable low voltage cutoff with settings for 3-cell Li-Po (9V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V) or 74% of battery beginning voltage
Programmable throttle input range (1.1ms???1.9ms or 1.2ms???1.8ms)
Programmable soft start for helis and airplanes
Car motor closed down if signal is lost or there is interference
Programmable timing???5 user-selectable ranges for usage with a large variety of brushless motors
Makes use of brand-new smaller sized MOSFET technology to minimize weight
Radio system power on/off switch
Pre-wired adapters???E-flite® EC3T port on battery input and 3.5mm gold bullet adapters on motor output leads

Specifications
Amperage: 40-60
Brake: Yes - Programmable
Cells w/BEC: 3-6S Li-Po or 9-18 Ni-MH/Ni-Cd
Continuous Maximum Current: 50 - 75A
Height: 0.61 in (15.5mm)
Input Connector Types: EC3
Input Voltage: 10.8V - 22.2V
Length: 2.85 in (73.0mm)
Brief Peak Current: 15 sec @ 75A with correct cooling air flow
Output Connector Types: 13 AWG with 3.5mm female gold bullet adapters
Type: Brushless
Weight: 2.65 oz (75.0 g)
Width: 1.30 in (33.0mm)
Wire Gauge: 13AWG