E-Flite 60-Amp Pro Switch-Mode BEC Brushless ESC (V2)

The E-flite® 60-Amp Pro Switch-Mode BEC Brushless ESC (V2). This is a top quality sensorless brushless electronic speed control with an incorporated switch-mode BEC that is extremely light-weight and efficient. It can operate without the requirement for a different receiver battery to power your servos and receivers, conserving you weight and complication.

Features
Up to 60 amps constant current with proper air flow and 75 amps burst current (15 seconds)
5A constant current, 5V switch-mode BEC circuit (proper cooling and air flow needed)
More powerful BEC for support of many 3-axis stabilization systems
Drive up to 7 analog or 6 digital standard-sized servos with the BEC on any suggested input voltage
3- to 6-cell Li-Po, 9- to 18-cell Ni-MH/Ni-Cd input voltage
Finned heat sinks
Programmable motor braking
Safe power-arm mode avoids unexpected starts
Programmable low voltage cutoff with settings for 3-cell Li-Po (9V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V) or 74% of battery beginning voltage
Programmable throttle input variety (1.1ms???1.9ms or 1.2ms???1.8ms)
Programmable soft start for helis and airplanes
Auto motor shut down if signal is lost or there is disturbance
Programmable timing???5 user-selectable varieties for usage with a large range of brushless motors
Utilizes brand-new smaller MOSFET innovation to decrease weight
Radio system power on/off switch
Pre-wired ports???E-flite® EC3T adapter on battery input and 3.5mm gold bullet ports on motor output leads

Specs
Amperage: 40-60
Brake: Yes - Programmable
Cells w/BEC: 3-6S Li-Po or 9-18 Ni-MH/Ni-Cd
Continuous Maximum Current: 50 - 75A
Height: 0.61 in (15.5mm)
Input Port Types: EC3
Input Voltage: 10.8V - 22.2V
Length: 2.85 in (73.0mm)
Temporary Peak Current: 15 sec @ 75A with proper cooling air flow
Output Port Types: 13 AWG with 3.5mm female gold bullet ports
Type: Brushless
Weight: 2.65 oz (75.0 g)
Width: 1.30 in (33.0mm)
Wire Gauge: 13AWG