E-Flite 60-Amp Pro Switch-Mode BEC Brushless ESC (V2)

The E-flite® 60-Amp Pro Switch-Mode BEC Brushless ESC (V2). This is a high-quality sensorless brushless electronic speed control with an incorporated switch-mode BEC that is very lightweight and effective. It can run without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication.

Features
Approximately 60 amps constant present with appropriate air flow and 75 amps rupture present (15 seconds)
5A constant present, 5V switch-mode BEC circuit (appropriate cooling and air flow required)
More powerful BEC for support of most 3-axis stabilization systems
Increase to 7 analog or 6 digital standard-sized servos with the BEC on any recommended input voltage
3- to 6-cell Li-Po, 9- to 18-cell Ni-MH/Ni-Cd input voltage
Finned heat sinks
Programmable motor braking
Safe power-arm mode prevents unexpected starts
Programmable low voltage cutoff with settings for 3-cell Li-Po (9V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V) or 74% of battery starting voltage
Programmable throttle input variety (1.1ms???1.9ms or 1.2ms???1.8ms)
Programmable soft start for helis and aircrafts
Vehicle motor closed down if signal is lost or there is disturbance
Programmable timing???5 user-selectable ranges for use with a large variety of brushless motors
Makes use of new smaller MOSFET technology to reduce weight
Radio system power on/off switch
Pre-wired ports???E-flite® EC3T adapter on battery input and 3.5mm gold bullet ports on motor output leads

Specifications
Amperage: 40-60
Brake: Yes - Programmable
Cells w/BEC: 3-6S Li-Po or 9-18 Ni-MH/Ni-Cd
Constant Maximum Current: 50 - 75A
Height: 0.61 in (15.5mm)
Input Port Types: EC3
Input Voltage: 10.8V - 22.2V
Length: 2.85 in (73.0mm)
Momentary Peak Current: 15 sec @ 75A with appropriate cooling air flow
Output Port Types: 13 AWG with 3.5mm female gold bullet ports
Type: Brushless
Weight: 2.65 oz (75.0 g)
Width: 1.30 in (33.0mm)
Wire Gauge: 13AWG