E-Flite 60-Amp Pro Switch-Mode BEC Brushless ESC (V2)

The E-flite® 60-Amp Pro Switch-Mode BEC Brushless ESC (V2). This is a high-quality sensorless brushless electronic speed control with an integrated switch-mode BEC that is really lightweight and effective. It can operate without the requirement for a different receiver battery to power your servos and receivers, saving you weight and complication.

Features
Up to 60 amps continuous present with appropriate air flow and 75 amps rupture present (15 seconds)
5A continuous present, 5V switch-mode BEC circuit (appropriate cooling and airflow required)
More powerful BEC for support of most 3-axis stabilization systems
Drive up to 7 analog or 6 digital standard-sized servos with the BEC on any advised input voltage
3- to 6-cell Li-Po, 9- to 18-cell Ni-MH/Ni-Cd input voltage
Finned heat sinks
Programmable motor braking
Safe power-arm mode avoids unexpected starts
Programmable low voltage cutoff with settings for 3-cell Li-Po (9V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V) or 74% of battery beginning voltage
Programmable throttle input variety (1.1ms???1.9ms or 1.2ms???1.8ms)
Programmable soft start for helis and planes
Vehicle motor shut down if signal is lost or there is interference
Programmable timing???5 user-selectable ranges for usage with a large range of brushless motors
Uses new smaller sized MOSFET technology to reduce weight
Radio system power on/off switch
Pre-wired adapters???E-flite® EC3T connector on battery input and 3.5mm gold bullet adapters on motor output leads

Specs
Amperage: 40-60
Brake: Yes - Programmable
Cells w/BEC: 3-6S Li-Po or 9-18 Ni-MH/Ni-Cd
Constant Optimum Current: 50 - 75A
Height: 0.61 in (15.5mm)
Input Connector Types: EC3
Input Voltage: 10.8V - 22.2V
Length: 2.85 in (73.0mm)
Temporary Peak Current: 15 sec @ 75A with appropriate cooling air flow
Output Connector Types: 13 AWG with 3.5mm female gold bullet adapters
Type: Brushless
Weight: 2.65 oz (75.0 g)
Width: 1.30 in (33.0mm)
Wire Gauge: 13AWG