E-Flite 60-Amp Pro Switch-Mode BEC Brushless ESC (V2)

The E-flite® 60-Amp Pro Switch-Mode BEC Brushless ESC (V2). This is a high-quality sensorless brushless electronic speed control with an integrated switch-mode BEC that is really light-weight and efficient. It can operate without the requirement for a separate receiver battery to power your servos and receivers, conserving you weight and complication.

Features
Approximately 60 amps constant existing with correct air circulation and 75 amps break existing (15 seconds)
5A constant existing, 5V switch-mode BEC circuit (correct cooling and airflow required)
More powerful BEC for assistance of many 3-axis stabilization systems
Increase to 7 analog or 6 digital standard-sized servos with the BEC on any suggested input voltage
3- to 6-cell Li-Po, 9- to 18-cell Ni-MH/Ni-Cd input voltage
Finned heat sinks
Programmable motor braking
Safe power-arm mode prevents unexpected starts
Programmable low voltage cutoff with settings for 3-cell Li-Po (9V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V) or 74% of battery beginning voltage
Programmable throttle input range (1.1ms???1.9ms or 1.2ms???1.8ms)
Programmable soft start for helis and planes
Vehicle motor closed down if signal is lost or there is interference
Programmable timing???5 user-selectable ranges for usage with a large variety of brushless motors
Uses new smaller MOSFET technology to reduce weight
Radio system power on/off switch
Pre-wired connectors???E-flite® EC3T connector on battery input and 3.5mm gold bullet connectors on motor output leads

Specs
Amperage: 40-60
Brake: Yes - Programmable
Cells w/BEC: 3-6S Li-Po or 9-18 Ni-MH/Ni-Cd
Continuous Maximum Current: 50 - 75A
Height: 0.61 in (15.5mm)
Input Adapter Types: EC3
Input Voltage: 10.8V - 22.2V
Length: 2.85 in (73.0mm)
Temporary Peak Current: 15 sec @ 75A with correct cooling air circulation
Output Adapter Types: 13 AWG with 3.5mm female gold bullet connectors
Type: Brushless
Weight: 2.65 oz (75.0 g)
Width: 1.30 in (33.0mm)
Wire Gauge: 13AWG