E-Flite 80-Amp Pro Switch-Mode BEC Brushless ESC, EC5 (V2)

When efficiency matters in your high-current applications, look no more than the E-flite® 80-amp Pro switch-mode ESC. This is a premium, efficient sensorless brushless electronic speed control with an integrated switch-mode BEC. It can run without the requirement for a separate receiver battery to power your servos and receivers, saving you weight and problem. It is capable of as much as 80 amps continuous existing when using 3- to 6-series Li-Po battery packs. You can drive up to 7 analog or 6 digital standard-size servos with the BEC on any suggested input voltage. Featuring an exposed, finned heat sink aluminum case with light-weight plastic end-caps, safe power-arming along with advanced programmable features such as low voltage cutoff, braking, timing, throttle input variety and more, the E-flite 80-amp Pro switch-mode ESC is really a 'pro series' electronic speed control.

This item is not intended for usage by children under 14 years of age without direct adult supervision.

Features
As much as 80 amps continuous existing with proper air circulation and 100 amps burst existing (15 seconds)
5V switch-mode BEC efficient in 5 amps continuous existing with 6 amps max burst on any suggested input voltage
Drive up to 7 analog or 6 digital standard-size servos with the BEC on any suggested input voltage
3- to 6-cell Li-Po, 9- to 18-cell Ni-MH/Ni-Cd input voltage
Programmable motor braking
Safe power-arm mode prevents accidental starts
Programmable low voltage cutoff with settings for 3-cell Li-Po (9.2V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V) or 74% of battery starting voltage
Programmable throttle input variety (1.1ms-1.9ms or 1.2ms-1.8ms)
Programmable soft start-up rate - .25 second or 1 second
Car motor closed down if signal is lost or there is interference
Programmable timing-5 user-selectable ranges-use with a big range of brushless motors
Two running modes-Airplane or Heli
Pre-wired connectors-E-flite EC5 on battery input and 4.0mm female gold bullets on motor output leads

Specs
Amperage: 60 & Up
Car Cutoff: Yes
BEC Continous Current: 5A
BEC Voltage: 5.5V Switch-mode
Brake: Yes
Cells w/BEC: 9-18 cells NiMH, 3-6S LiPo
Constant Maximum Current: 75 - 100A
Forward: Yes
Height: 0.62 in (15.5mm)
Input Adapter Types: EC5, 10AWG leads
Length: 3.0 in (77mm)
Temporary Peak Current: 100A (15 seconds) Proper Cooling Required
Output Adapter Types: 4mm Gold Bullet, 12AWG leads
Overload Security: Yes
Dead time Brake: Yes
Type: Brushless
Weight: 3.75 oz (106 g)
Width: 1.6 in (41mm)