E-Flite 80-Amp Pro Switch-Mode BEC Brushless ESC, EC5 (V2)

When efficiency matters in your high-current applications, look no further than the E-flite® 80-amp Pro switch-mode ESC. This is a high-quality, efficient sensorless brushless electronic speed control with an integrated switch-mode BEC. It can run without the requirement for a separate receiver battery to power your servos and receivers, saving you weight and problem. It is capable of as much as 80 amps continuous current when using 3- to 6-series Li-Po battery packs. You can drive up to 7 analog or 6 digital standard-size servos with the BEC on any suggested input voltage. Featuring an exposed, finned heat sink aluminum case with lightweight plastic end-caps, safe power-arming in addition to advanced programmable features such as low voltage cutoff, braking, timing, throttle input variety and more, the E-flite 80-amp Pro switch-mode ESC is really a 'professional series' electronic speed control.

This product is not meant for usage by kids under 14 years of age without direct adult supervision.

Features
As much as 80 amps continuous current with proper air circulation and 100 amps burst current (15 seconds)
5V switch-mode BEC efficient in 5 amps continuous current with 6 amps max burst on any suggested input voltage
Increase to 7 analog or 6 digital standard-size servos with the BEC on any suggested input voltage
3- to 6-cell Li-Po, 9- to 18-cell Ni-MH/Ni-Cd input voltage
Programmable motor braking
Safe power-arm mode avoids accidental starts
Programmable low voltage cutoff with settings for 3-cell Li-Po (9.2V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V) or 74% of battery starting voltage
Programmable throttle input variety (1.1ms-1.9ms or 1.2ms-1.8ms)
Programmable soft start-up rate - .25 2nd or 1 2nd
Automobile motor shut down if signal is lost or there is interference
Programmable timing-5 user-selectable ranges-use with a big variety of brushless motors
2 running modes-Airplane or Heli
Pre-wired connectors-E-flite EC5 on battery input and 4.0mm female gold bullets on motor output leads

Specs
Amperage: 60 & Up
Automobile Cutoff: Yes
BEC Continous Current: 5A
BEC Voltage: 5.5V Switch-mode
Brake: Yes
Cells w/BEC: 9-18 cells NiMH, 3-6S LiPo
Continuous Optimum Current: 75 - 100A
Forward: Yes
Height: 0.62 in (15.5mm)
Input Connector Types: EC5, 10AWG leads
Length: 3.0 in (77mm)
Temporary Peak Current: 100A (15 seconds) Appropriate Cooling Needed
Output Connector Types: 4mm Gold Bullet, 12AWG leads
Overload Defense: Yes
Time Delay Brake: Yes
Type: Brushless
Weight: 3.75 oz (106 g)
Width: 1.6 in (41mm)