E-Flite 40-Amp Lite Pro Switch-Mode BEC Brushless ESC (V2)

The E-flite® 40-Amp Lite Pro Switch-Mode BEC Brushless ESC (V2). This is a high-quality sensorless brushless electronic speed control with an integrated switch-mode BEC that is very lightweight and effective. It can run without the requirement for a separate receiver battery to power your servos and receivers, saving you weight and issue.

Features
Approximately 40 amps continuous present with proper air flow and 55 amps break present (15 seconds)
5A continuous present, 5V Switch-Mode BEC Circuit (Proper cooling and air flow required)
Stronger BEC for assistance of many 3-axis stabilization systems
Drive up to 7 analog or 6 digital standard-sized servos with the BEC on any recommended input voltage
3- to 6-cell Li-Po, 9- to 18-cell Ni-MH/Ni-Cd input voltage
Programmable motor braking
Safe power-arm mode prevents unintentional starts
Programmable low voltage cutoff with settings for 3-cell Li-Po (9.2V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V) or 74% of battery beginning voltage
Programmable throttle input variety (1.1ms???1.9ms or 1.2ms???1.8ms)
Programmable soft start for helis and airplanes
Auto motor shut down if signal is lost or there is disturbance
Programmable timing???5 user-selectable ranges, utilize with a big range of brushless motors

Specifications
Amperage: 40-60
BEC Voltage: 2.5A constant
Brake: Yes
Constant Optimum Current: 25 - 50A
Height: 0.47 in (12mm)
Input Connector Types: 13 AWG with E-flite EC3 Connector
Input Voltage: 3S-6S LiPo or 9- to 18-cell Ni-MH/Ni-Cd
Length: 2.6 in (66mm)
Short-lived Peak Current: 55A
Output Connector Types: 16AWG with 3.5mm Female Gold Bullet Connectors
Type: Brushless
Weight: 1.7 oz (48g)
Width: 1.2 in (31mm)