Dumas Taylorcraft Kit

This is the radio controlled, electrical powered
Dumas Taylorcraft Park Flyer Kit.

FEATURES:
Building: Hand selected laser cut balsa
Vacuum formed cowl
Rudder and Elevator Control: Wire pushrod
Servo Positioning: Installed in rails on fuselage
Landing Gear: 1/16" diameter wire front, tail wire skid
    requires bending

INCLUDES:
All balsa, lightweight colored (blue and yellow) tissue covering
    two 1-3/4" (45mm) lightweight foam main wheels, tail wire skid,
    lightweight plastic tail wheel, CA hinges and all hardware to
    total set, instruction manual, two full-size strategy sheets,
    acetate sheet for windows and vacuum formed cowl.

REQUIRES:
GWS IPS (indoor power system) motor with "A" ratio gear drive
    GWSG2023
3 channel radio system (minimum)
2 micro servos
5A ESC w/BEC GWSM2059
2 cell 700mAh LiPo battery
GWS 8x6 prop, GWSQ2017
Structure and field devices

SPECIFICATIONS:
Length: 23-7/8" (606mm)
Wingspan: 40" (1016mm)
Wing Area: 272sq.in. (17.57 sq dm)
Airfoil: Flat bottom
Center of mass (CG): 1-7/8" (48mm) back from the leading edge
    of the wing
Control Tosses-
    Elevator, Up and Down: 3/4" (19mm)
    Rudder, Left and Right: 7/8" (22mm)