Dubro Xl Micro Servo Arm For Futaba/ Hitec/E-Flite/Hurricane

This is the XL Micro Servo Arm set by Dubro.

FEATURES:
Plastic building

INCLUDES:
(4) Single-sided servo horns
(2) Dual-sided servo horns

NEEDS:
Futaba 3108M S3110M, Hitec HS-50/HS-55, E-Flite S75 servo

SPECIFICATIONS:
Single-sided horn length: 28.70mm
Dual-sided horn length: 51.45mm

Frequently gotten with the product that you are presently checking out.

Hs-55 Sub Micro Servo, .14Sec/18Oz @ 6.0V

    This is the Hitec HS-55 Sub Micro (Feather) Servo with a
Futaba J, Hitec S, JR, Airtronics Z-type Connector.

FEATURES:
Really slim case and light-weight for mounting in little planes,
    electrics or gliders, where very high speed and good torque are
    critical.
One of the slimmest micro servos available.
High-strength resin gear train provides dependable operation.

INCLUDES:
One HS-55 Servo w/pre-installed little X-shaped servo horn and screw
One very little straight servo horn
One M1.7x3 servo horn screw
One little straight servo horn
Two M1.7x7 servo mounting screws

at 4.8V
SPECIFICATIONS:
Speed: 0.17 sec at 60°
Output Torque: 15.27 oz-in (1.1 kg-cm)
Weight: 0.27oz (7.8g)
Length: 0.89" (22.8mm)
Width: 0.45" (11.6mm)
Height: 0.94" (24mm)

The below product also pairs truly well with the product being reviewed.

6x4 Thin Electric Prop

This is a 6x4E Thin Composite propeller from Advanced Precision Composites.
For use on Electric powered aircraft just (not for glow engines).

FEATURES:
Gray composite propeller blades that assemble onto a propeller hub.
Comes with 2 adapter rings that adapt to different motor shafts.
Comes in a bag attached to a header card.

INCLUDES:
One composite propeller
Two composite adapter rings
One direction sheet

NEEDS:
Assembly onto motor or gear drive system in your Electric plane.
Balancing

SPECIFICATIONS:
Size: 6"
Pitch: 4
Hub inner diameter: 0.25"

COMMENTS:
Use Speed 400 Electric motors.